Maintenance And Repair Instructions; Line Installation For The Speedspool - Troy-Bilt TBSS Manual Del Operador

Ocultar thumbs Ver también para TBSS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE AND REPAIR INSTRUCTIONS

LINE INSTALLATION FOR THE SPEEDSPOOL

Always use Genuine Factory Parts™ 0.080 inch (2.03 mm)
replacement line. Line other than specified may make the
engine overheat or fail.
WARNING: Never use metal-reinforced line,
wire, or rope, etc. These can break off and
become a dangerous projectile.
There are two methods to replace the SpeedSpool®
trimming line.
• Wind the inner reel with new line
• Install a prewound inner reel
Winding the Inner Reel With New Line
NOTE: It is unnecessary to remove the bump knob to
install new trimming line.
1. Cut two pieces of 0.080 inch (2.03 mm) trimming
line, 10 feet (3 m) long.
WARNING: Always use the correct line length
when installing trimming line on the unit. The line
may not release properly if the line is too long.
2. Hold the outer spool and turn the inner reel
counterclockwise to line up the arrows on the outer
spool and inner reel (Fig. 8).
3. Pull old line out of the line loading and line locking
holes (Figs. 9 and 10).
4. Insert a piece of trimming line into one of the two
eyelets in the outer spool. Push it up through the line
loading hole in the inner reel (Fig. 9). Do not bend the
line when inserting it into the eyelet.
Top View Of The SpeedSpool
Outer Spool
Inner Reel
®
Arrows
Bump Knob
Fig. 8
®
Trimming Line
5. Insert the line into the locking hole (Fig. 10). Do not
push the line more than 1/2 inch (12.7 mm) into the
line locking hole. When inserted correctly the line
will form a small loop (Fig. 10).
6. Pull the line from the outer spool until the line is tight
against the inner reel (Fig. 11).
Eyelet
Line Loading Hole
Fig. 9
Line Locking Hole
Fig. 10
Fig. 11
9

Publicidad

Tabla de contenido
loading

Tabla de contenido