Safety Instructions - AquaPRO 54064-0 Manual Del Propietário

PERFORMANCE
Model
54064-0

SAFETY INSTRUCTIONS

1. This equipment is only for use with an automotive, tractor or marine type battery fully charged to 12 Volts DC.
Battery current can cause severe burns and start a fire if the battery is short circuited.
Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the
State of California to cause cancer and reproductive harm.
Wash hands after handling.
2. Do not pump flammable or explosive liquids such as oil, gasoline, kerosene, ethanol, etc. Do not use in the
presence of flammable or explosive vapors. Using this pump with or near flammable liquids can cause an
explosion or fire, resulting in property damage, serious personal injury, and/or death.
3. ALWAYS disconnect the power to the pump before servicing.
4. Do not touch the motor housing during operation. The motor is designed to operate at high temperatures. Do
not disassemble the motor housing.
5. Do not handle the pump or pump motor with wet hands or when standing on a wet or damp surface, or in
water before disconnect the power.
6. Release all pressure and drain all water from the system before servicing any component.
7. Extension cords may not deliver sufficient voltage to the pump motor. Extension cords present a life
threatening safety hazard if the insulation becomes damaged or the connection ends fall into water. The use
of an extension cord to power this pump is not permitted..
8. Wear safety goggles at all times when working with pumps..
9. Use insulated crimp type connectors
10. Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the cord. Do not
use damaged or worn cords.
11. Failure to comply with the instruction and designed operation of this unit may void the warranty. ATTEMPTING
TO USE A DAMAGED PUMP can result in property damage, serious personal injury, and/or death..
12. Secure the discharge line before starting the pump. An unsecured discharge line will whip, possibly causing
personal injury, and/or property damage..
13. Do not lift the pump by the power cord..
14. Know the pump and its applications, limitations, and potential hazards.
15. Periodically inspect the pump and system components to ensure the pump suction screen is free of mud,
sand, and debris. Disconnect the pump from the power supply before inspecting.
16. Follow all local electrical and safety codes, along with the National Electrical Code (NEC). In addition, all
Occupational Safety and Health Administration (OSHA) guidelines must be followed.
17. Ensure the electrical power source is adequate for the requirements of the pump.
18. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the
hose is not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of
water quickly, and also check that all hose connections are tight to minimize leaks.
GPH of Water @ Total FeetOf Lift
HP
0 ft. 10 ft.
1/10 300 250
20 ft. 30 ft.
180 110
2
Max. Lift
40 ft.
25 43 ft.