Gude GDS 125-12 Traducción Del Manual Original página 26

ENGLISH
22
Failure removal
Failures
Not working when pressing the
on-off switch.
Grinding discs do not turn when
tool is switched on.
Device is not running at full speed
or unusual sounds from motor.
Sanding belt flies out.
Possible causes
No electricity
On/off switch is defective
Wear on the rubber drive wheels. Increase the contact pressure
Motor is overheating
Motor defective
Band history set incorrectly.
Recommended solution
Check the electricity supply
Have on-off switch replaced by
an approved after-sales service
team.
using the setscrew until the
grinding discs start turning
again.
Turn off device and leave to cool
for 30 minutes.
Contact an approved after-sales
service provider.
Correct until band stays in the
middle.