REMOvING THE REFRIGERATOR
AccESSORIES
1. Door Bins & Dairy Compartment
· Door bins (1)
To remove - Simply lift the bin up and pull
straight out.
To put back - Slide it in above the desired
location and push down until it stops.
· Door bins (2)
To remove - Take the right side of the bin out by
lifting it obliquely along the guide and then, take
the left side out by pulling it from the door.
To put back - Slide it into the original
location and push down until it is sticks.
Injury may occur if the door bins are not
firmly positioned.
cAuTION
Do not allow children to play with bins.
Sharp corners of the bins may cause injury.
Do not adjust a bin full of food. Remove the
food first. To remove dust, remove the guard
and wash in water.
2. Tempered Glass shelves
• To remove-Tilt up the
front of the shelf in the
direction shown ( 1 )
and lift it up vertically
( 2 ).
Pull the shelf out.
• To put back-Tilt the
front of the shelf up
and guide the shelf
hooks into the slots at
a desired height. Then,
lower the front of the
shelf so that the hooks
can drop into the slots.
The Tempered Glass shelves are heavy.
Use special care when removing them.
cAuTION
74_ operating
(1)
(2)
2
3. vegetable & Fruit Drawers
• To remove-Pull the drawer out to full extension.
Tilt up the front of the drawer and pull straight out.
• To put back-Insert the drawer into the frame rails
and push back into place.
The drawers need to be removed before the
glass shelf above them can be lifted out.
cAuTION
4. Flex zone
• To remove the Flex Zone–Pull the Flex door out
to full extension. Lift the Flex Zone up, pulling it to
your body with both hands.
• To put the Flex Zone back–Open the Flex door
to full extension. Tilt the front of the Flex Zone up,
place the back of the Flex Zone onto the rails, and
then lower the front until the whole Zone rests on
the rails.
When the Flex Zone or LED lighting are not
working, check the connectors [ ( 1 ), ( 2 )
shown below] for cracks or leaks.
1
2
1