Sachtler Ace Base Plate Manual De Instrucciones página 8

EN EN
Camera slide plate clamping screw
The Ace Base Plate allows the camera slide plate to be locked at any chosen position. The
camera slide plate clamping screw is located on the left-hand side of the Ace Base Plate.
Slide release button
The red slide release button, when pressed, allows the Ace slide plate to be removed from the
Ace Base Plate. The slide release button is located on the aft left-hand side of the Ace Base
Plate.
Head slide plate attachment
The head slide plate is secured to the underside of the Ace Base Plate using either 1/4 in. or 
3/8 in. camera fixing screws.
Support rod adjustment clamp
The Ace Base Plate allows support rods (x2) to be fitted and adjusted as required. The support
rods are fitted into the support rod housing and secured by the support rod clamp, located on
the forward left-hand side of the Ace Base Plate.
Camera height adjustment clamp
The camera height can be adjusted by raising or lowering the upper platform of the Ace Base
Plate. When the camera is at the required height, the Ace Base Plate can be secured in place
by the camera height clamp. The camera height clamp is mounted on the right-hand side of the
Ace Base Plate.
Camera mounting
The camera is attached to the Ace Base Plate using an Ace slide plate, that is attached to the
camera and then loaded from the rear of the platform and secured in position by the camera slide
plate clamping screw. 

The Ace slide plate is supplied with 1/4 in. camera fixing screw and pin and a DSLR anti-twist
block. The anti-twist block prevents the DSLR camera from twisting side to side, when fitted.
Additionally, two spare camera screws are located in the screw stowage position on the
underside of the Ace slide plate
NOTE: Some cameras, including DSLRs, do not require the pin. Remove the 1/4" camera fixing
screw to release the pin plate.
-4-