Watts BT-WR02 RF Guía De Usuario página 5

3. Installation and RF Initialisation rules
Install and plug the receiver into the following guidelines to guaranty an optimal reception:
- The receiver must be put at a minimum distance of 50cm of all others electrical or wireless materials
like GSM, Wi-Fi router.
- Before wiring work related to the receiver must be carried out only when de-energized
- Connect your receiver to the power supply.
Following your installation an order of pairing must be respected for a correct RF initialisation.
Installation 1: Receiver + RF thermostat
1. The receiver must be put in RF init mode by 5sec pressing on the RF Button.
2. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode
waiting for a thermostat configuration address.
Please refer to the thermostat leaflet for enter the thermostat in "RF Init" mode.
3.
4. The receiver RF LED must be switched OFF and the thermostat should exit the RF init mode to indicate
correct paring between both elements.
Installation 2: Receiver + RF Thermostat + RF Central
Make the "Installation 1" rules for pairing with the thermostat.
1.
2. The receiver must be put one time more in RF init mode by 5sec pressing on the RF Button.
3. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode
waiting for a thermostat configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init".
4.
5. The receiver RF LED must be switched OFF and the Central will show a message to indicate correct paring
between both elements.
Installation 3: Receiver + Central
1. The receiver must be put in RF init mode by 5sec pressing on the RF Button.
2. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode
waiting for a Central configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init".
3.
4. The receiver RF LED must be switched OFF and the Central will show a message to indicate correct paring
between both elements.
Remarks:
- The BT-WR02 RF receiver can be linked with a BT-PR02 RF or BT-FR02 RF receivers as slaves unit.
- In case of loss RF communication (RF Alarm), the receiver will follow 20% cycle of heating to prevent the
installation against frost. (The receiver will stay in OFF mode if it was in OFF before loss of RF
communication).
- The LEDs are turned off from 8pm to 8am; a short press on the RF key reactive the LEDs for a short time
5