Grundig WK 8680 Manual De Instrucciones página 16

OPERATION­ ______________________________
Preparation
1­­
R emove all packaging and sticker materials
and dispose of them according to the applica-
ble legal regulations.
2­­ B efore using the appliance for the first time,
clean all parts which come into contact with
water carefully. (See the "Cleaning and care"
section).
3­­
C ompletely roll out the power cord from the
cable coil on the bottom of the base
J
Pass the power cord through the slot on the
base.
4­­ C lean the kettle well before initial use and dis-
card water of first two boiling cycles.
Operation
1­­
P ush the lid release button
open the lid .
C
2­­
F ill the water tank
A
Notes
Do not place the water tank
7
while filling it with water.
J
Never fill the water tank
7
mum level indicator or below the minimum
level indicator.
3­­ C lose the lid until it clicks into place.
C
4­­
P lace the water tank
sure that it is placed in an upright and stable
position.
5­­ I nsert the plug into the wall socket.
― The actual temperature of water will be
shown on the display.
6­­
S et the water temperature to any desired value
(40-100) by pressing the temperature setting
button (+/-).
D
7­­
P ush On/Off button
be heard once. The button's light will be on
during operation. Once the desired tempera-
ture is attained, the light disappears and the
operation is finished. You will hear 3 warning
(beep) sounds.
16 ENGLISH
on the kettle to
C
with water.
on the base
A
above the maxi-
A
on the base J . Make
A
.A warning beep will
G
8­­ I f desired, the simmer function can be activated
by pressing button
– Indicator light of button
If the simmer function is activated, the kettle
7
will restart the boiling process when the tem-
perature falls below the desired temperature.
After 30 minutes, simmer function will be can-
celled automatically.
Warm-keeping button
7
from 50 °C to 90 °C.
.
K
Note
Lid should always be closed during the
C
7
boiling process; otherwise the kettle will not
switch off automatically.
Note
If you want to stop the boiling process manu-
7
ally, push the On/Off button
9­­
Disconnect the plug from the wall socket.
10­­Take the water tank from the base
hold it by the handle
Caution
Do not open the lid
7
splash out. Make sure that no water splashes
onto the base.
11­­Pour the water from the spout
or glass you want to use.
Hints­and­Tips
If you want to continue the boiling process, re-
7
peat the procedure from 1 to 10.
Let the kettle cool down between each heating
7
process.
The kettle is equipped with a water filter
7
which filters out limestone and other residues
when the water is being poured out.
Use softened or filtered water to prevent lime
7
build-up.
.
F
lights on.
F
operates in a range
F
G .
. Only
J
.
I
as hot water could
C
to the cup
B
B