The GENIUS5 has seven (7) modes: Standby, 12V, 12V AGM, 12V LITHIUM, 6V, REPAIR and FORCE. Some charge modes must be pressed and held for three (3) to five (5)

seconds to enter the mode. These "Press and Hold" modes are advanced charging modes that require your full attention before selecting. It is important to understand the

differences and purpose of each charge mode. Do not operate the charger until you confirm the appropriate charge mode for your battery. Below is a brief description:

Mode

Explanation

In Standby mode, the charger is not charging or providing any power to the battery. Energy Save is activated during this mode, drawing microscopic power

Standby

from the electrical outlet. Canbus is enabled in Standby mode. When in Standby, the orange Standby LED will illuminate.

No Power

For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries. When selected, the 12V white LED will illuminate.

14.5V | 5A | Up To 120Ah Batteries

For charging 12-volt AGM batteries. When selected, the 12V AGM white LED will illuminate.

14.8V | 5A | Up To 120Ah Batteries

For charging 12-volt lithium-ion batteries, including lithium iron phosphate. When selected, the 12V Lithium blue LED will illuminate. For use on

batteries with Battery Management Systems (BMS) only.

14.6V | 5A | Up To 120Ah Batteries

For charging 6-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries. When selected, the 6V white LED will illuminate.

Press & Hold

7.25V | 5A | Up To 120Ah Batteries

(3 Seconds)

Force Mode

For charging batteries with a voltage lower than 1V. Press and Hold for five (5) seconds to enter Force Mode. The selected charge mode will then operate

under Force Mode for five (5) minutes before returning to standard charging in the selected mode.

Press & Hold

(5 Seconds)

5A | Up To 120Ah Batteries

An advanced battery recovery mode for repairing and restoring, old, idle, damaged, stratified or sulfated batteries. When selected, a red LED will

illuminate and flash.

16.5V | 5A | Any Capacity

(Peak Voltage Measured At 25°C, Amperage Rating Is Bulk Amperage When Above 0°C)

[From Standby Press and Hold 3 Seconds With Clamps Connected to the Battery]

Tabla de Contenido