Switching The Mobile On And Off; Start-Up Guide - Konrow Slider Guia Del Usuario

Safety information for charging the battery:
• To recharge the battery, only use the mains adaptor
supplied with your device. Do not use any other power supply
or electrical device. The power outlet to which the device is
connected must be near the equipment and must always be
easily accessible.
• Always wait at least 5 seconds after switching off the device
before restarting it. Switching the device off and then back on
again immediately may damage the electrical circuits.
• Do not disassemble the battery. Do not dispose of batteries
in fire or water. Do not charge the battery if the room
temperature exceeds 45°C.
• For all repairs or to replace the battery, consult a qualified
technician.
• The lifetime of the battery depends largely on how you use
it. Do not expose the battery to temperatures less than 0°C or greater than 60°C. Its performance
may be altered.
• Significant electromagnetic interference or electrostatic discharge may cause
malfunction or loss of data. If the device is not working properly, restart the mobile or
unplug the mains adaptor from the power outlet then plug it in again.

4. Switching the mobile on and off

Start-up guide

5. Locking/Unlocking SIM cards
Your Slider is a dual SIM mobile. It enables you to phone using two lines from the same
device. There are two SIM card slots.
• When you start up your phone, the latter invites you to enter the PIN codes of your two
SIM cards in succession (SIM1 then SIM 2).
• The ''emergency call'' function enables you to call an emergency number without
entering the PIN code.
To switch the mobile on, press the On/Off button located
on the side of the mobile for 3 seconds.
If the mobile is switched on, press for less than a second
on the button to put the device into standby mode. Slide
up your Slider to leave standby mode.
To switch off the mobile, press the On/Off button for 3
seconds until a menu appears, then touch the Off button
and confirm.