GE 34343 Manual Del Usuario página 4

5. Use a 1/8" drill bit and carefully drill
the two holes marked in step 4.
6. Use your hammer and lightly tap in
the supplied drywall anchors until
they are flush with receptacle.
7. Use your Phillips screwdriver. Screw in
the screws provided until they
stick out about 1/16".
8. Mount the antenna onto the screws by
lining up the keyhole slots on the back
of the antenna with the screws.
Be sure you have routed the coax cable in the
direction you want the cable to go by using the
cable channel on the bottom of the antenna.
Installation:
1. Attach the coax cable from the antenna
to the power amplifier "Antenna"
2. Connect the attached coax
cable from the amplifier labeled
"Receiver" to the back of the TV
3. For televisions equipped with USB ports:
Connect the supplied USB cable to the USB
port on the amplifier, then connect the
other end to your television's USB port.
For televisions without USB ports:
Connect the supplied USB cable to the USB
port on the amplifier, then connect the
other end to the supplied AC adapter. Plug
the AC adapter into an available outlet.
4. Turn on your TV
5. Scan for your local TV channels following the
instructions found in your TV's users manual
3