N-Com "900" / "600" Series Intercom Function (One-To-One Connection); 13 "Universal Intercom" Intercom; Pairing Up The Universal Intercom; Universal Intercom Function - Nolangroup n-com R Serie Manual De Instrucciones

12.2 N-Com "900" / "600" Series Intercom function (one-to-one connection)

To establish an Intercom connection with one of the systems stored in memory, simply press the command
related to the channel where the system was saved.
Connection CHANNEL 1
Call CHANNEL 2
Call CHANNEL 3
Disconnection of active intercom
N.B.: In case the pre-setting position is empty, or the system being called cannot be reached within the
maximum range or it is already engaged in a phone call, you will hear an error voice message.
N.B.: In case the Intercom connection system falls outside the range (Intercom connection interrupted), the
B601 system will automatically try to reconnect every 8 seconds. Double beeps will be emitted until the
Intercom connection is not restored.
If you do not want automatic reconnection, press the "n" key to stop the automatic reconnection attempts.
13 "UNIVERSAL INTERCOM" INTERCOM
The N-Com B601 system can be connected via Bluetooth to intercom systems of other brands or to N-Com
systems other than the "900" / "600" series
Important: N-Com systems other than the "900" / "600" series must be paired up to the N-Com B601 by
following the procedure "Pairing up the Universal Intercom".

13.1 Pairing up the Universal Intercom

The N-Com system can be paired up to the other intercom (from now on referred to as Intercom B) as if it was
a mobile phone.
Make sure the B601 is turned off.

Put the system in the "Configuration" mode: press the "n" key and keep it pressed for 4 seconds, until you

hear the voice announcement " Configuration Menu ".
Press the "" key until you reach the option " Universal intercom pairing ".

 Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual).
After a few seconds, Intercom B will emit the confirmation beep.

N.B.: The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.

13.2 Universal Intercom Function

To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B601 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 12).
Intercom B may receive a dialing tone that must be answered with a phone reply command.
From intercom B
Press the " Voice call / Dial last number called " command.
To disconnect the intercom, press " Hanging up/rejecting a phone call " command.
Note:
During use of the UNIVERSAL INTERCOM, the B601 system keeps the connection active to the MAIN

DEVICE only (and not to the SECONDARY DEVICE).
The intercom system connected to N-Com B601 may not allow simultaneous connection to a mobile

phone.
Only one system paired up in Universal Intercom mode can be stored.

1
Except for Bluetooth kit and Bluetooth kit2, which are not compatible
Briefly press "n".
Press the "n" key twice.
Press the "n" key three times.
Briefly press "n".
1
, thanks to the UNIVERSAL INTERCOM function.
19