Operation - Storm Surge SS20T Manual Del Operador

CAUTION
DO NOT START YOUR WATER PUMP UNIT UNTIL
YOU HAVE READ THE ENGINE MANUAL THAT
CAME WITH YOUR ENGINE, AND THE "WARNINGS
AND SAFETY PRECAUTIONS" SECTION IN THIS
MANUAL.
NEVER STORE ENGINE WITH FUEL IN THE TANK
INDOORS. FUEL AND FUEL VAPORS ARE HIGHLY
FLAMMABLE.
NEVER ADD FUEL WHEN ENGINE IS RUNNING OR
HOT FROM OPERATION. NEVER FILL THE TANK
INDOORS. DO NOT SMOKE WHEN FILLING FUEL
TANK.
AN ADULT MUST ALWAYS HANDLE AND FILL THE
ENGINE WITH FUEL.
ALWAYS HANDLE FUEL IN A WELL VENTILATED
AREA, OUTDOORS, AWAY FROM FLAMES OR
SPARKS.
DO NOT START ENGINE IF FUEL IS SPILLED. WIPE
OFF EXCESS FUEL AND ALLOW TO DRY. REMOVE
ENGINE FROM AREA TO AVOID SPARKS.
MAKE SURE THE UNIT IS IN A STABLE POSITION
BEFORE PULLING THE STARTER HANDLE.
IF ENGINE FAILS TO START AFTER TRYING
STARTING PROCEDURES, PLEASE CONTACT OUR
CUSTOMER SERVICE DEPARTMENT AT 800-345-
6007.
STARTER ROPE CAN CAUSE AN UNANTICIPATED
JERK TOWARDS ENGINE.
INSTRUCTIONS TO AVOID INJURY.
NEVER LEAVE ENGINE
UNATTENDED. TURN OFF AFTER EVERY USE.
NEVER CARRY PUMP FROM ONE LOCATION TO
ANOTHER WHILE ENGINE IS RUNNING.
NEVER RUN ENGINE INDOORS OR IN ENCLOSED,
POORLY VENTILATED AREAS. ENGINE EXHAUST
CONTAINS CARBON MONOXIDE, AN ODORLESS
AND DEADLY GAS.
KEEP HANDS, FEET, HAIR AND LOOSE CLOTHING
AWAY FROM ANY MOVING PARTS ON ENGINE AND
EQUIPMENT.
DO NOT OPERATE PUMP WHEN DISCHARGE IS
BLOCKED OR STOPPED.
DO NOT OPERATE THE PUMP DRY. IF THE PUMP
IS OPERATED DRY THE PUMP SEALS WILL BE
DAMAGED. IF THE PUMP HAS OPERATED DRY,
STOP THE ENGINE IMMEDIATELY. ALLOW THE
PUMP TO COOL AND INSPECT FOR DAMAGE
BEFORE OPERATING AGAIN.
Check for parts online at www.stormsurgepumps.com or call 800-345-6007 M-F 8-5
PLEASE FOLLOW
RUNNING WHILE

OPERATION

1. Fill the engine crankcase with oil. Refer to the engine
operating manual for the specific grade of oil and amount
required.
2. Fill the engine fuel tank with gasoline. Refer to the engine
operating manual for specific gasoline type that is most
efficient for this engine.
3. Add water to the priming port on the pump. SEE FIGURE
6. Continue to add water until the water level is above the
inlet port of the pump. Install the priming plug. The water
in the pump will create the suction that primes the pump.
4. Refer to the Engine Manual that came with your pump for
engine start and operation procedures.
NOTE: The pump may take several minutes to prime.
Do not use this pump for suction lifts over 26 feet.
IMPORTANT
AN AIR LEAK IN THE SUCTION LINE MAY PREVENT
PRIMING OF THE PUMP. USE OF THREAD SEALANT
IS RECOMMENDED.
DO NOT OPERATE THE PUMP DRY. IF THE PUMP
IS OPERATED DRY THE PUMP SEALS WILL BE
DAMAGED. IF THE PUMP HAS OPERATED DRY,
STOP THE ENGINE IMMEDIATELY. ALLOW THE
PUMP TO COOL AND INSPECT FOR DAMAGE
BEFORE OPERATING AGAIN.
Operator's Manual
SS20T and SS30T Water Pumps
11