SIMMONS KIDS CRIB ‘N’ MORE Instrucciones De Ensamble página 11

-WARNINGS FOR DAY BED OPTION ONLY-
ANY MATTRESS USED IN THIS BED SHALL BE A FULL-SIZE CRIB MATTRESS HAVING A MINIMUM DIMENSION OF 51 5/8"
(1310 MM) IN LENGTH AND 27 1/4" (690 MM) IN WIDTH WITH A THICKNESS OF AT LEAST 4" (100 MM).
THE MINIMUM AGE SHALL NOT BE LESS THAN 15 MONTHS AND A MAXIMUM WEIGHT SHALL NOT BE GREATER THAN 50
LBS (22.7 KGS).
NOTE: WHEN INSERTING SCREWS/BOLTS, TURN CLOCKWISE UNTIL TIGHT, THEN LOOSEN 1/2 - 3/4 OF A TURN,
AFTER CRIB 'N' MORE IS COMPLETELY ASSEMBLED, RETURN TO EACH SCREW/BOLT AND TIGHTEN. USE WAX
OR SOAP ON ALL SCREWS/BOLTS TO EASE ASSEMBLY.
STARTING FROM CRIB:
STEP #1: REMOVE FOOTEND ASSEMBLY (PART #13) BY REMOVING THE 4 - M6 X 40MM BOLTS (PART #12).
STEP #2: REMOVE MATTRESS SUPPORT ASSEMBLY (PART #8) FROM THE CRIB ASSEMBLY BY REMOVING THE 4 - M6
X 16MM BUTTON HEAD BOLTS (PART #11).
STEP #3: TAP ONE GATE PIN (PART #15) HALF WAY INTO EACH END OF THE DAY BED RAIL (PART #16).
STEP #4: USING THE M4 HEX WRENCH PROVIDED, ATTACH THE DAY BED RAIL (PART #16) USING 2 JOINT CONNECTING
BOLTS (PART #14) BETWEEN THE LEFT AND RIGHT POSTS.
STEP #5: REATTACH MATTRESS SUPPORT WITH THE 4 BOLTS (PART #11). NOTE: BE SURE MATTRESSS SUPPORT IS IN
THE LOWEST POSITION.
STEP #6: TIGHTEN ALL BOLTS CLOCKWISE.
STARTING FROM SCRATCH:
STEP #1: FOLLOW STEP #1 IN THE CRIB ASSEMBLY INSTRUCTIONS.
STEP #2: FOLLOW STEPS #3 TO #6 FOR THE DAY BED ASSEMBLY INSTRUCTIONS LOCATED ABOVE (STARTING FROM
CRIB).
DAY BED ASSEMBLY INSTRUCTIONS
DAY BED RAIL (PART #16)
JOINT CONNECTING BOLT (PART #14)
USE M4 HEX WRENCH PROVIDED