Wall Mounting - Qwest CID98-LS Manual De Instrucciones

W A L L M O U N T I N G
1. Hold the wall mounting bracket against the wall and use a pencil to
mark the position of the mounting holes.
2. Remove the bracket and drill two holes into the wall to install the
plastic expanding wall anchors (not supplied).
3. Press a plastic anchor into each hole
and gently tap the anchors into the wall with a hammer until the
anchors are completely seated.
1 2
4. Attach the wall mounting bracket to the anchors using two screws.
5. Connect the phone cords to the Call Waiting ID unit
(see Step 1 of Set-up Instructions on Page 2).
6. Slide the unit down onto the wall mounting bracket until it
snaps into place.
7. Plug the power adapter into a wall outlet not controlled by a
wall switch and plug the power adapter jack into the top of the
Call Waiting ID unit.
1 3