Charging Your Iphone Or Ipod; Listening To The Fm Radio - Altec Lansing Mix Guia Del Usuario

Charging Your iPhone or iPod

Whenever your iPhone or iPod is docked and your Altec Lansing inMotion
Max speaker system is plugged into an AC outlet, your iPhone or iPod is
charging (until fully charged) – even if the speaker system is switched off.
cAUTioN: The iPhone or iPod will not charge when the speaker system is
operating on batteries.

Listening to the FM Radio

1
extend the FM antenna fully for
best FM reception.
2
Select "FM" mode.
Press the "SOURCE" button on your
speaker system or clip-on remote until
"FM" appears on the LCD.
3
Tune to the station you want to
listen to.
Use the or buttons on your
speaker system or enhanced remote to
tune in the desired station. Press and
hold these same buttons to find the next clear FM station.
4
Adjust the volume.
Use the knob on your speaker system to adjust the system
volume. Or, use the "+" and "–" buttons on the clip-on remote.
How to Store Preset Stations
Your Altec Lansing Mix speaker system's clip-on remote enables you to
program up to 4 FM station presets:
1
2
3
How to recall Preset Stations
1
FM
2
3
Tune to the station you wish to store.
While in "FM" mode, use the or
or clip-on remote to tune to the desired station.
Store the station.
Press and hold the P1, P2, P3 or P4 button on the clip-on remote for
a few seconds. You can store one FM station in each preset.
To store other stations, repeat the above steps.
Make sure you are in "FM" mode.
If you're not in "FM" mode, press the "SOURCE" button on your
speaker system or clip-on remote until "FM" appears on the LCD.
Press a PReSeT button (P1, P2, P3 or P4) on the clip-on
remote.
The radio will tune to your preset station.
Adjust the volume.
Use the knob on your speaker system to adjust the system
volume. Or, use the "+" and "–" buttons on the clip-on remote.
buttons on your speaker system
15