3 41 01 121 21 0.book Seite 11 Montag, 22. August 2011 1:11 13
Extension cord
If the use of an extension cable
WARNING
is required, its length and con-
ductor cross-section must be adequate for the
applicational case, in order to prevent a volt-
age drop in the extension cable, power loss and
overheating of the power tool. Otherwise, the
extension cable and power tool are liable to
electrical danger, and the working efficiency is
impaired.
Intended use of the power tool.
Hand-guided angle grinder for dry grinding/
roughing and cutting of metal and stone in
weather-protected environments with the
application tools and accessories recommen-
ded by FEIN.
Operation of the power tool off power generators.
This machine is also intended to be pow-
ered by a. c. generators with sufficient
power output that correspond with
ISO 8528, design class G2. Compliance with
this Standard in particular is not given when
the so-called distortion factor exceeds 10%.
When in doubt, inform yourself about the
generator in use.
Symbols.
Symbol, character
Explanation
Action to be taken by the user
General prohibition sign. This action is forbidden!
Do not touch the rotating grinding wheels.
Observe the instructions in the text or graphic opposite!
Be absolutely sure to read the enclosed documentation such as the Instruc-
tion Manual and the General Safety Instructions.
Before commencing this working step, pull the mains plug out of the
socket. Otherwise there will be danger of injury if the power tool should
start unintentionally.
Use eye-protection during operation.
Recommended dimensions of extension cords
at an operating voltage of 120 V – single-phase
a. c., with only one power tool WSG10/WSG14/
WSS14 connected:
Max. cable length, ft
Max. cable length, m
≤ 100
100
200
–200
–300
Min. conductor size
Min. conductor
(A.W.G.)
cross-section, mm
16
14
12
Operating the power tool off
WARNING
power generators whose no-
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
en
11
≤ 30
30
60
– 60
–100
2
1.5
2.5
4