EB TECHNOLOGY START-S4XL Manual De Instrucciones página 25

START-S4XL
2.7 Connection of the STOP
18 19 20 21 22 23 23 24 25
You need to use any kind of button or contact provided it is type N.C. (normally closed)
to connect the safety devices. If there are several safety devices they have to be connected in series.
2.8 Connection of LIMIT SWITCHES LSO and LSC
12 13 14 15 16 17 18 19 20 21 22 23 23 24 25
OPEN
CLOSE
LIMIT
N.C.
N.C.
SWITCHES
MOT 2
2.9 Connection of Elec. lock 12 Vac
Aside is the layout of the connection of the 12 Vac elec. lock:
12 13 14 15 16 17 18 19 20 21 22 23 23 24 25
Connection of the STOP command:
Button: stops and inhibits temporarily the
control unit until a new command.
Switch: keeps the automation blocked until
a new retrieval is ordered.
OPEN
CLOSE
LIMIT
N.C.
N.C.
SWITCHES
MOT 1
The picture shows the connection of both limit
switches.
The limit switch contacts must be N.C.
(normally closed) contacts.
!
If the LSO or LSC inputs
aren't in use, follow the
instructions you fi nd
in chapter 5
2.10
During the program, to avoid any interfe-
rences, we recommend to disconnect the
antenna!
21 22 23 23 24 25
If you are using a piece of
stiff wire instead of an anten-
na, to obtain a 433Mhz fre-
quency you have to cut it off
to 17 cm e connect it to the
clamp no. 25
-7-
Technical Manual
!
If the STOP input is
NOT used put the
DIP 6 C on ON.
Connection of ANTENNA