TROUBLESHOOTING
Factory Reset: Press and hold the
switch on.
Speaker will not turn on:
• On back of the system, make sure the power switch has been turned on.
• Make sure that the power cord has been plugged directly into a wall outlet
and that the green LED on the power supply block is ON.
Bluetooth device will not connect
• Make sure the system has been set to Bluetooth mode(Blue status light),
and that Bluetooth is enabled on your device.
• Make sure your Bluetooth device is within 30ft of the system.
• It is possible that another device is currently connected. Press and hold the
| AUX button on the system to enter pairing mode (status light fl ashes blue)
and pair your device again.
• Perform factory reset and pair your device again.
No Sound from Bluetooth device
• Make sure device is connected to dock and audio is playing.
• Make sure volume is turned up on device and on the speaker.
Red Light
• Unplug power for 10 minutes.
• If red light continues, call KICKER Customer Service at (405) 624-8510.
DISCLAIMER: Bluetooth wireless audio compatible with most Bluetooth enabled phones, tablets and computers
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all the instructions listed in this manual. Keep these instructions and heed all warnings. Follow all safety and
procedural recommendations to prevent damage to your self, your KICKER product, or your portable media device.
The Amphitheater K3 should not be used near water or in an environment where exposure to liquids is possible. This
includes but is not exclusive to areas where splashing, dripping, leaks, spills, and exposure to rain can occur. Liquid
containers should not be placed on or near the Amphitheater K3. The Amphitheater K3 should not be cleaned with liquid
cleaners. Use only a dry cloth to clean the Amphitheater K3.
Only use the Amphitheater K3 in areas with adequate open ventilation allowing at least 4" of space on all sides of the
Amphitheater K3. Do not set the Amphitheater K3 on any surface or cover the Amphitheater K3 with any object that could
impede the airfl ow to and from the Amphitheater K3. The Amphitheater K3 should not be placed near any source of heat.
The battery pack or batteries installed shall not be exposed to excessive heat. This includes but is not limited to stoves,
radiators, heating elements, electronic heat sources, and areas where excessive solar heat can be generated. Do not place
the Amphitheater K3 near any fl ame or place any fl ammable objects near the device.
The power outlet used to provide power to the Amphitheater K3 should be accessible at all times. The power cord
should be situated in a way that protects it from being pinched, walked on, tripped over, or accidentally pulled from the
electrical outlet or the electrical input on the Amphitheater K3. Where the MAIN plug or an appliance coupler is used
as the disconnect device, the disconnect device shall remain readily operable. Do not run the cable through doorways
or underneath objects that could damage the wire or tear the insulating material surrounding the wire. Only use the
manufacturer supplied power supply with the Amphitheater K3. We recommend using a surge protector/power conditioner
and unplugging the Amphitheater K3 during any electrical storms or situations that could cause voltage fl uctuations in the
electrical system.
6
iK3BT User Manual Rev 9.indd 6
iK3BT User Manual Rev 9.indd 6
| AUX button while turning the Power
ENGLISH
11/25/2013 9:49:34 AM
11/25/2013 9:49:34 AM