Castolin Eutectic ArcWeld 484 P Manual Tecnico página 23

NOTE: DO NOT USE THE NEUTRAL OF THE POWER SUPPLY SYSTEM
FOR GROUNDING.
All electrical connections must be firmly tightened to avoid sparkling risks,
overheating or circuit voltage drop.
5.3) Installing the wire feeder
1)Connect the wire feeder to the power source through the command cable.
2)Fix the welding cable to the + terminal of the power source in the terminal of the wire feeder.
3)Fix the hose of the gas pressure regulator to the inlet nipple of the back solenoid valve of the wire feeder.
4)Install the welding gun (see specific manual).
5)Install the wire.
6)Install the feed rollers according to the wire type and diameter to be used.
TABLE 5.1
Diameter Type
Ø mm
0,6 - 1,2 Fe,Ss,C
0,9 - 1,6 Fe,Ss,C
1,2 Fe,Ss,C
1,4 - 1,6 Fe,Ss,C
2,0 - 2,4 Fe,Ss,C
1,2 - 1,6 C
2,0 C
2,4 C
1,0 - 1,6 Al
1,2 Al
C=Cored
Wire
24
ArcWeld 484 P
ATTENTION!
The wire feed mechanism can be hurt. Be carefull.
1 2
Feed Arm Output
Roller Nozzle
FEED ROLLERS
3 4 Groove
Intermediare Type
Nozzle
V
V
V
V
V
V - K
V - K
V - K
U
U
K = Knurled
= Groove
Identification 1
1 0,6 - 0,8 0,9 - 1,0
6 0,9 - 1,0
7 1,2
2 1,4 - 1,6
2 1,4 - 1,6
3 1,2 1,4 - 1,6
3 1,2 1,4 - 1,6
4 2,4 Not Used
U4 1,0
U4 1,2
2 3
1,2
1,2 1,4 - 1,6
1,2 1,2
2,0 2,4
2,0 2,4
2,0
2,0
Not Used
1,2 1,6
1,2 1,2