For Your Safety; Technical Data; Machine Components - Würth PinPuller-Spot Instrucciones Para El Manejo

This
operated safely only if the
user
operating instructions and
the safety regulations and
if he/she closely adheres to
all the indications stated
therein.
Before using this device always
check the cable and the plug. If
any defects are noticed do not use
it.
If the device is to be repaired, only
a specialist should do so. Never
open this device on your own.

Technical data

Resistance-welding equipment:
Article number
Coupling voltage
Mains frequency
Mains protection
Rated output 50% ED
Max. welding output
Max. secondary current
Max. welding current
Secondary off-load voltage
Weld time
Control current connecting joints and bayonet
fittings
Protection rating
Weight
8

For your safety

device will
fully reads the
0691 500 290
220 – 230V
50 – 60 Hz
16 A sloggish
2 kVA
12 kVA
1.8 kA
1800 A
0.01 – 2 s
IP 21
16 Kg
be Before executing any work on the device
itself, pull the mains plug.
Do not make any conditioned changes from
the structure to the device.
This device might generate strong magnetic
fields and consequently damage clocks,
magnetic cards or other data carriers.
People with pace makers must first seek the
doctor's opinion before approaching the
work environment of this device.
It is advisable to wear protective goggles
and work gloves.
Before using the device the user should
remove jewelry, watches and any clothing
that contains high amounts of metal which
could heat up by induction.

Machine components

1 Control panel
2 Jack for weld gun
3 Current connecting joint for weld gun
4 Ground connecting joint
5 Current connecting joint for Dent Killer
6 Jack for Dent Killer
7 LED for weld gun welding times
8 LED for weld gun welding current
9 LED for Dent Killer welding times
10 LED for the welding current at the Dent Killer
11 LED for carbon electrode welding current
12 Autostart activation/deactivation LED
13 Program key arrow pointing up
14 Program key arrow pointing down
7 V
15 Display for welding times and current
16 Adjuster key for increasing values (+)
17 Adjuster key for decreasing values (-)
18 LED display indicating start of welding cycle
XLR
19 LED welding current
20 Lit mains switch.
21 Safety fuse
22 Mains cable