Important Notice - Chacon 34949 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Make sure this network icon
appears in the Status Bar
Normal Zone
:
Sensors set to Normal Zone are armed whether the alarm is in
Arm (Full Arm) or Home Arm (Part Arm) Mode. We recommend setting Window/
Door Sensors to Normal Zone.
Home Zone
:
Sensors set to Home Zone are only armed in Arm (Full Arm) Mode.
If Home Mode (Part Arm) is used, these Sensors are not armed and will not activate
the alarm on trigger. We recommend setting PIR Motion Sensors to Home Zone.
24 Hour Zone
:
Sensors set to 24 Hour zone will activate the alarm when
triggered, regardless of the alarm status at the time (armed or disarmed).
Note:
Smoke, Gas Leakage or Water Flood Sensors are automatically registered as 24 Hour
Zone Sensors and cannot be changed to Normal or Home Zone. Any Motion or Door/ Window
Sensor paired to the Control Panel by pressing the Tamper Switch will also register as a 24 Hour
Zone Sensor. A 24 Hour Sensor will activate the alarm when triggered, regardless of the alarm
status at the time (armed or disarmed). "
Internal Siren
The volume level, alarm duration, and arm/disarm beep can be adjusted in the App.
Wireless Siren
When connecting an Outdoor Siren (optional accessory) to the Control Panel, it
can be enabled/ disabled by switching the Alarm option to on/off. The on/off arm/
disarm beep and alarm duration can also be adjusted.
Exit Delay Time
Set a time delay for you to leave your property without triggering an alarm.
APP Control and Settings

Important Notice

In order to control the system remotely (WiFi/App), the Control Panel must be 'mains'
powered via the Power Adapter. WiFi accessibility is disabled when the Control
Panel Power Adapter is unplugged from the mains power supply and running on
batteries.
WiFi Indicator
Status Indicator
status
Entry Delay Time
Set a time delay for you to enter your property without triggering an alarm.
Timed Arm/Disarm
The system can be programmed to automatically Arm and Disarm the alarm at
1. Set the time you want the alarm to arm (on the left)
2. Tap the Arm Button once to activate automatic arming and twice to disable it
3. Set the time you want the alarm to Disarm (on the right)
4. Tap the Disarm Button once to activate automatic disarming and twice to disable
the automatic disarming
5. Select the days you want the alarm to automatically arm/ disarm
6. Slide the switch to the 'on' position to activate the new schedule
Access to an optional IP Camera
Pull down to refresh and see the 'Live Alarm' status
Arm
Disarm
Home Arm (Part Arm)
Synchronize Time (Important Setting)
The time shown on your mobile device must be synchronized with the time
shown on the Server prior to setup. Operation history will only be recorded once
synchronization is complete.
Edit Accessories
Rename, add, delete and change the Zone Mode of each Sensor. (except the 24
Hour Zone). Remember to tap the Save button in the top right hand corner to save
the changes.
Normal Zone (Switchable to Home Zone or 24 Hour Zone)
Home Zone (Switchable to Normal Zone or 24 Hour Zone)
24 Hour Zone (Unchangeable)
Ringtone of Push Alert
The selected ringtone will be heard when a Push Alert is received.
History
page 13).
Passcode
We recommend that passcode protection is enabled to avoid unauthorized access
to the App.
Delete User
The alarm can be controlled by up to 5 Users who will also receive Push Alerts. To
delete a User Account from the App go to the submenu 'More' and select 'Delete
Users'

Publicidad

Tabla de contenido
loading

Tabla de contenido