Additional Specific Safety Rules - Porter & Cable 7800 Manual De Instrucciones

Lijadora para paredes en seco
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

c) Disconnect the plug from the power source and/or the battery pack from
the power tool before making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits, etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.

ADDITIONAL SPECIFIC SAFETY RULES

SAFETY WARNINGS COMMON FOR GRINDING, SANDING, WIRE
BRUSHING, POLISHING OR ABRASIVE CUTTING-OFF OPERATIONS:
a) This power tool is intended to function as a sander. Read all safety
warnings, instructions, illustrations and specifications provided with this power
tool. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
b) Operations such as polishing, grinding, wire brushing or cutting-off are
not recommended to be performed with this power tool. Operations for
which the power tool was not designed may create a hazard and cause personal
injury.
c) Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can
be attached to your power tool, it does not assure safe operation.
d) The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool. Accessories running faster than their
RATED SPEED can break and fly apart.
e) The outside diameter and the thickness of your accessory must be
within the capacity rating of your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
f) The arbor size of wheels, flanges, backing pads or any other accessory
must properly fit the spindle of the power tool. Accessories with arbor
holes that do not match the mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or cracked wires. If power tool or accessory
is dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum
no-load speed for one minute. Damaged accessories will normally break apart
during this test time.
4 - ENG

Publicidad

Tabla de contenido
loading

Productos relacionados para Porter & Cable 7800

Este manual también es adecuado para:

7801

Tabla de contenido