Miter Gauge - Black and Decker BDTS100 Manual De Instrucciones

NOTE: Before tightening the wing nut (M) Fig. 15,
make certain a gap of at least 1/8" is between the
bottom edge of the splitter (N) and the top surface of
the table (P) and that the protrusions (K) are inside
the slot of the splitter assembly (H).
8. Use a straight edge to see if the splitter (H)
Fig. 16 is aligned with the saw blade (R). If an
adjustment is necessary, the splitter (H) can be
moved left or right and rotated.
9. When the splitter is properly aligned with the saw
blade, tighten the screws (C) and (G) Fig. 17.
R

MITER GAUGE

The miter gauge is shipped assembled and is supplied
with a T-slot bar (A) Fig. 18 that is inserted into either one
of the two T-slotted miter gauge grooves (B) located in
the table top. The T-slot prevents the miter gauge from
falling when it is extended beyond the front of the table
when cross-cutting extra wide workpieces.
ATTACHING MITER GAUGE HOLDER
DISCONNECT MACHINE FROM POWER SOURCE.
E
F
Fig. 16
B
Fig. 19
P
H
G
A
A
G
13
N M
Fig. 15
C
Fig. 17
Fig. 18
Fig. 20
H
K
B