Before Use - Polaris 2830428 Instrucciones De Funcionamiento Y Manual De Piezas

Before Use

1. Before using this product, read the operator's manual
completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards
associated with its use.
2. Verify that the product and application are compatible,
if in doubt call Customer Service (888) 332-6419.
3. Inspect jack stands before each use. Ensure that all
parts move freely. Do not use if there are bent, broken
or cracked components noted.
ASSEMBLY
1. Fasten the Ranger/RZR attachment to the PVL2300
lift saddle with the provided bolts.
2. To use the RZR attachment, remove the hitch
connector by unscrewing the adjustment knob. Attach
the RZR attachment with the attachment bolt.
OPERATION
1. Line up vehicle undercarriage with load supports. To
adjust the position of the swivel arms, pull the swivel
lock down to disengage the lock. Then rotate the arm
to the desired position and release the lock.
!
WARNING: Ensure the swivel lock is completely
engaged before lifting the vehicle.
2. Lift saddle to just before contact to ensure the contact
area will be in a proper location.
!
WARNING: Use only on hard, level surfaces capable
of sustaining rated capacity loads.
3. Line up vehicle hitch adapter with product's hitch
connector.
4. Close Hydraulic Release Valve and carefully pump
jack until vehicle reaches desired height. Final height
must correspond with the locking teeth on the Height
Locking Lever.
5. Carefully turn the Release Knob counterclockwise
until the Lift Platform engages the Height Locking
Lever, then close the Release Knob by turning it
fully clockwise. Do not work around or under load
unless Height Locking Lever is properly engaged.
!
CAUTION: Clear all tools and personnel before
lowering load. Only attachments and/or adapters
supplied by the manufacturer shall be used with
this device.
6. To lower the Lift Platform pump the Lift Pedal several
times to disengage the Height Locking Lever, then
depress the Height Unlocking Lever pedal. Carefully
turn the Release Knob counterclockwise to lower the
load slowly.
! WARNING
• Study, understand and follow all instructions before
operating this device.
• Use of this product is limited to lifting, lowering and
holding loads consisting of a single vehicle whose
lifting points are compatible with the lifting platform.
Incompatibility is evident when the loaded vehicle
wobbles, appears unstable, and/or does not
securely engage the lift platform.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Center load on lift platform.
• Immediately after lifting load, ensure Height
Locking Lever is engaged.
• Engage locking caster mechanism before working
on or around loaded lift. Do not move or dolly load
supported by this device.
• Restraining an incompatible load will not make the
load secure and may cause unexpected loss of
load.
• Never work on, around or under a load that is not
secured and stable.
• Keep operator's and bystander's head, hands and
feet away from lift arms when raising and lowering.
• No alterations shall be made to this product.
• Failure to heed this warning may result in personal
injury and/or property damage.
Figure 2: Mounting Ranger/RZR attachment.
3