Genius Car Alarm
Genius Car Alarms
Function 5 / Automatic Re-Arming
This function is programmed in the memory of the alarm system as a preventive function, if that
becomes necessary when you disarm the alarm system by remote control and has not entered the
vehicle and passed Swiche ignition to the ON position, the LED panel began blinking rapidly, after
90 seconds the alarm system is armed again confirming 1 siren sound and 1 flash of lights, if
function 15 is set to ON, the electric insurance are closed, protecting the vehicle again until you
take it apart again.
Function 6 / Acoustic warning to Arm and Disarm
Selection 1: (ON)
When arming the alarm system, the siren will sound warning one armed, to disarm the alarm system,
the siren will sound 2 sounds.
Selection 2: (OFF)
When arming the alarm system, the siren will not sound, but if a door is open when arming the alarm,
the siren emits 3 warning sounds. To disarm the alarm, the siren will not sound, but if the alarm
trigger, the siren sounds emit 4 warning shot.
Note: to arm and disarm the alarm system only get the warning light, 1 flash of light armed ,
disarmed 2 flashes of light.
Function 7 / Exclusion of false alarm
The security system is designed and programmed to sound the siren a period of 30 seconds, in the
case of any attempted theft which makes the siren sounds more than 30 seconds period , arriving
at 3 minutes of sound the siren automatically mutes the security system siren and excludes sensor
activated zone, protecting the vehicle with the other sensors, a function that also applies to the
impact sensor 10 continuous shots Pre - warning.
Function 8 / Anti hijack by remote control (Genius Control).
This function is used to immobilize the vehicle in case of emergency by pressing the 3 button
remote control Genius for 3 seconds while the vehicle engine is running, the vehicle lights will 2
flashes, the indicator LED will start flashing indicating activation anti - hijack, if the audible warning
is programmed the siren will sound one.
Function 9 / Delay line pushbuttons (Dome Ligth).
This function is necessary for those cases where the vehicle leaves the internal ceiling light time
after closing all the doors with the engine off.
Selection 1 (ON)
The alarm system will give a delay line buttons 60 seconds.
Selection 2 (OFF)
The alarm system will not delay line switches.
Note : If the setting 1 is chosen, after 60 seconds after the alarm armed and a door remains open,
the siren will open warning 3 door.
Function 10 / Anti hijack by ignition.
The anti-hijack is immediately activated whenever the ignition key is passed from the OFF position
to the ON position.
Function 11 / 3rd channel.
Channel 3 alarm system is completely independent of channel 2 opens electric trunk, this was
designed to be used by pressing simultaneously buttons 3 and 4 on the remote control can be
used to activate optional modules such as module ignition, module for electric glass, Etc.
34
www.geniuscaralarm.com
12
www.alarmasgenius.com