Troubleshooting Guide - Black and Decker ELECTROMATE 400 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

90556511 VEC026BD.qxp:VEC026BD ManualENSP 061808

TROUBLESHOOTING GUIDE

Jump Starter
Problem
Possible Cause
Jump starter will not jump start a
ON/OFF switch is not in the ON
vehicle
position
Unit beeps continuously when
Cables are connected incorrectly,
connected to a car battery
activating the Reverse Polarity
Alarm
Unit doesn't turn on
Unit's internal battery is depleted
120 Volt AC Accessory Outlet (Inverter)
Problem
Possible Cause
No AC output; green LED is lit
Battery voltage below 10.5 volts
No AC output; green LED is flashing Excessive load – thermal shut down Unplug appliance(s). Wait
Motorized power tool won't start
Excessive start-up current
Snow in television picture;
Interference
"buzz" in audio speaker(s)
Inverter initially powers, then
Equipment being operated draws
automatically shuts down
too much power
12 Volt DC Accessory Outlets
Problem
Possible Cause
Accessory Outlet will not power
• Excessive load
appliance
• Unit's internal Battery is depleted
Inflator
Problem
Possible Cause
Inflator turns ON, but will not inflate
Chuck is not properly inserted into
the tire
tire valve
Inflator will not turn ON
• Inflator is overheated
• Unit's internal battery is depleted
12/11/09
2:02 PM
Solution
Turn ON/OFF switch in the rear of
the unit to the ON position.
Disconnect the cables/clamps and
match the polarity of the clamps
with the polarity of the battery
before attempting to reconnect
according to the vehicle's battery
specifications.
Recharge unit (refer to the
"Charging/Recharging" section of
this instruction manual).
Solution
Recharge unit (refer to the
"Charging/Recharging" section of
this instruction manual).
approximately 10 minutes for
Accessory Outlet to cool down.
Reduce load to 400 watts.
Appliance will not work with
inverter.
Keep inverter and antenna distant
from each other, use shielded
antenna cable connect antenna to
amplifier.
Reduce load to maximum 400 watts
Solution
• Unplug appliance. Wait
approximately 10 minutes for
Accessory Outlet to cool down.
Reduce load to 60 watts/5 amps.
• Recharge unit (refer to the
"Charging/Recharging" section of
this instruction manual).
Solution
Remove chuck and make sure it is
properly inserted into tire valve.
• Turn Inflator OFF. Wait
approximately 10 minutes for it to
cool down; then turn back ON.
• Recharge unit (refer to the
"Charging/Recharging" section of
this instruction manual).
10
Page 10
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center.
If you need assistance regarding accessories, please call: 1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and
reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page
directory under "Tools—Electric" or call: 1-800-544-6986 or visit www.blackanddecker.com.
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship.
The defective product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased
(provided that the store is a participating retailer). Returns should be made within the time period of the retailer's
policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with
the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service
Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and
authorized Service Centers are listed under "Tools-Electric" in the yellow pages of the phone directory and on our
website www.blackanddecker.com.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other
rights which vary from state to state or province to province. Should you have any questions, contact the
manager of your nearest Black & Decker Service Center. This product is not intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call
1-800-544-6986 for a free replacement.
SPECIFICATIONS
12 Volt DC Specifications
Battery:
12 volt DC rechargeable, maintenance-free
Internal Battery Type:
Sealed, AGM lead-acid
Internal Battery Capacity:
12 volt 17Ah/20 hour rate
Area Light :
Light Emitting Diode (LED)
Jumper Cables:
Heavy duty cable with 450 amp clamps
Accessory Outlet Protection:
5 amp, dual self-resetting breakers
DC Charging Adapter:
12 volt DC
AC Power Specifications
Output Power:
Continuous — 400 watts
Output Voltage:
120 VAC RMS
Output Frequency:
60 Hz ±4 Hz
Output Waveform:
Modified sine wave
Overheat Protection:
Yes
Overload Protection:
Yes
Output Short Circuit Protection:
Yes
Tire Inflator Specifications
Maximum Pressure:
120 PSI
Battery Charger Specifications
Input:
120 volt AC, 60 Hz
Rapid Charging Current:
12 volt DC 1000mA
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
See 'Tools-
Electric'
– Yellow Pages –
for Service &
Sales
11

Publicidad

Tabla de contenido
loading

Tabla de contenido