Installation Tips; Cleaning And Storing - CertainTeed NO-COAT PRO Manual De Instrucciones

Adjusting hopper gates
Adjust the hopper gates to reduce leakage
while ensuring suffi cient coverage. If the
gates are too tight the product may jam in
the NO-COAT PRO.
1. Adjust gate by loosening knob and sliding
the gate up or down. Tighten the knob once
the gate is in position.
2. As the viscosity of your joint compound
may vary from bucket to bucket, you may
need to adjust the hopper gates periodically
to get the desired coverage.
3. If you are getting coverage inconsistency, check your joint compound thickness and
add water as needed.

INSTALLATION TIPS

Use a roller tool for best results.
Use a roller to achieve the best installation results,
prevent high-siding, achieve an even taper on both
sides of the corner and get a straight corner edge.
To use: install mudded side of NO-COAT PRO
Corner to corner. Place a roller over corner and
roll with consistent, smooth pressure.
USAGE STATISTICS
1. Press MENU and select "5 - Usage Statistics". The display will indicate how many
feet and corners the NO-COAT PRO has dispensed in its lifetime.
USING STAND-ALONE HOPPER
The NO-COAT PRO hopper can be used
separately from the NO-COAT PRO machine to
apply joint compound to other corner products.
1. Remove the hopper from the machine.
2. Extend both hopper supports.
3. Place the hopper onto a 5-gallon bucket, making
certain the hopper supports are fully extended and
hooked over the edge of the bucket.
4. Push the corner through the inlet gate of the hopper.

CLEANING AND STORING

Cleaning the NO-COAT PRO
WARNING - DO NOT IMMERSE OR SPRAY-DOWN THE NO-COAT PRO CUTTER,
ELECTRONICS, OR WIRING.
1. Unplug the NO-COAT PRO before cleaning.
®
20 NO-COAT PRO INSTRUCTION MANUAL
Hopper Gate
Adjustment Knob
Hopper Supports Extended
Hopper
Gates