Installation Instructions; Refrigerator; Door Alignment - GE GSE22 Manual Del Propietario E Instrucciones De Instalación

Installation Instructions

Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT
•
for local inspector's use
IMPORTANT
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer –
future reference.
• Skill level –
basic mechanical skills.
• Completion time –
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
CAUTION
Lifting Hazard.
Single person lift can cause injury. Use assistance
when handling, moving or lifting the refrigerator doors.
NOTE: When moving door, to prevent damage to
door and electronics carefully place the door in a
proper location.
WARNING
To reduce the risk of electric shock
or injury during installation, you must first unplug the
instructions can result in electrical shock.
REFRIGERATOR LOCATION
often enough to maintain proper temperatures.
perform properly.
water (rain, etc.) or direct sunlight.
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
door opening which provides better access to food
storage area.
14
—
Save these instructions
—
Observe all governing
15 minutes

Refrigerator

Models 20, 22, 25
WATER SUPPLY TO THE ICEMAKER
(on some models)
connected to a cold water line. A GE Appliances
water supply kit is available at extra cost from your
dealer, by visiting our Website at GEAppliances.com
(in Canada, at geappliances.ca), or from Parts and
ROLLERS
The rollers have 3 purposes:
Rollers adjust so the door closes easily when
opened about halfway.
Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
Rollers allow you to move the refrigerator away
from the wall for cleaning.
To adjust the rollers, remove
the base grille by pulling it out
at the bottom.
Turn the roller adjusting
screws clockwise to
raise the refrigerator,
counterclockwise to lower it. Use an adjustable
hex head bolt) or pliers.
To replace base grille, line
up the clips on back of grille
between the bar and the
bottom of the cabinet. Push
forward until grille snaps into
place

DOOR ALIGNMENT

After leveling, make sure that
doors are even at the top.
To make the doors even,
adjust the refrigerator door.
wrench, turn the door
adjusting screw to the
right to raise the door,
to the left to lower it. (A
nylon plug, embedded in
the threads of the pin,
prevents the pin from
turning unless a wrench
is used.)
2. After one or two turns of
the wrench, open and
close the refrigerator
compartment door and check the alignment at the
top of the doors.
Wrench
To remove
the base
grille, open
the doors and
then pull the
grille straight
Raise
out.
49-60514-11