Selecting A Call- Ring Tone; Setting The Roger Beep - BRONDI FX-400 Twin Manual De Instruccion

Channel scan perform searches for active signals in an endless loop for all 8 channels, 38
CTCSS codes and all 83 DCS codes.
a. Press the MENU button 5 times
b. Press the UP or DOWN button to begin scanning channels when an active
signal is detected, channel scan pauses on the active channel.
c. Press the MENU button again, CTCSS flashes on the LCD screen press the
UP or DOWN button to begin scanning CTCSS 1-38.
d. Press the MENU button again, DCS flashes on the LCD screen. Press the UP
or DOWN button to begin scanning DCS code 1-83.
e. Press the PTT button to confirm your setting.
3.7 Vibrator and Call alert
Your FX-400 can alert you to incoming signal by emitting an audible call tone and vibration
signal.
3.8 Call-Ring tone
You can send a Call-ring tone to other PMR users to give an alert that you want to
communicate with them.
Press the CALL button
Yu will hear a ring tone for about two seconds; "TX" appears on the LCD Screen. Any
other units within the transmitting range and turned to the same channel and
sub-channel ( if applicable) will hear the Call-ring tone.

3.9 Selecting a Call- Ring tone

The FX-400 is equipped with 5 different types of Call-Ring tones.
a. Press the MENU button 8 times, the LCD Screen will display Call Icon and
blinking.
b. Press the UP or DOWN button to select the desired Call-ring tone. A respective
Call- Ring tone sound will be played when changing from one tone to another.
c. Press the PTT button to confirm your setting.
3.10 Activating the Vibrator mode
a. Press the MENU button 9 times; "0I" flashes on the LCD Screen.
b. Press the UP OR DUWN button to activate the vibrator function.

3.11 Setting the Roger Beep

The Roger Beep is a tone which is automatically transmitted whenever the PTT button is
released. This alerts the receiving party to inform that you have intentionally ended the
transmission, and you are now in receive mode.
a. Press the MENU button 10 times, "ON" flashes on the LCD Screen.
b. Press the UP or DOWN button ("ON" will be displayed on the LCD screen) or
deactivate ("OFF" will be displayed on the LCD screen)
c. Press the PTT button to confirm your setting.
- 8 -