Maintenance; Propane Tank Changing Tips; Maintenance Schedule - Mosquito Magnet Commander Manual De Operación

Ocultar thumbs Ver también para Commander:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance

If using one of our Fuel-Saving Modes, be sure to adjust the dates
on the chart below (see chart on page 11 to coordinate the
maintenance schedule with the mode of operation).
• 21 Day Maintenance Cycle - for Optimal Performance
- Refill propane. (Propane lasts approximately 21 days with
24-hour/7-days operation.)
- Replace short-range attractant cartridge.
See Mosquito Magnet
attractant label for instructions.
®
- Empty or replace bug bag.
- Utilize the Quick Clear adapter at every tank change.
• Periodically wipe down the outside of the trap
with a clean, water damp cloth.
• Charge your battery for 24 hours at the beginning of the season.

Maintenance Schedule

Purchase Date
Register Warranty
Start Up Date
SERVICE:
Seasonal Tune-Up
MAINTENANCE:
Propane, Attractant & Bug Bag Change
Quick Change Cartridge
Propane, Attractant & Bug Bag Change
Quick Change Cartridge
Propane, Attractant & Bug Bag Change
Quick Change Cartridge
Propane, Attractant & Bug Bag Change
Quick Change Cartridge
Propane, Attractant & Bug Bag Change
Quick Change Cartridge
SERVICE - WINTERIZATION
Discard Bug Bag & Attractant
Cover Trap Trumpet to avoid
nesting insects
Keep in garage or shed
Maintenance
Note: Bug bags should be replaced when half full. You can find all your accessory needs
Possible Cause
at www.mosquitomagnet.com or at your Certified Mosquito Magnet Hardware or Home Improvement Store.
Example
Season 1
4/1
4/1
4/1
4/21
4/21
5/11
5/11
5/31
5/31
6/20
6/20
7/10
7/10

Propane Tank Changing Tips

When attaching the regulator knob to a tank after a tank change,
be sure to fully tighten the regulator knob onto the tank. No need
to use tools, but do turn the knob as far as possible by hand.
When this is done, loosen the knob 1/4 turn, then re-tighten to
maximize seal.
The purpose for this is to fully engage the regulator onto the tank. If
the regulator is not fully engaged, the flow of gas may be restricted
to the point where the trap will show a gas empty code. If this
occurs, press the off button, close the tank valve, and remove the
regulator from the tank. Re-attach the regulator and try again.
Season 2
3/15
Season 3
Season 4
12

Publicidad

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Mosquito Magnet Commander

Este manual también es adecuado para:

Executive

Tabla de contenido