Sammic DS-12 Instrucciones página 16

4) Now with the
regeneration to take place on.
5) Press so the triangle starts to blink.
6) Press to confirm (the day will be underlined). The water softener will carry out the
regeneration on the underlined days (fig. 15).
7) Press to confirm.
8) Select the days on which you want the regeneration to take place.
9) Press until a letter is displayed on the screen (fig. 16).
DOSAGE OF SALT FOR THE REGENERATION
fig. 16
The value "salt amount" determines the regeneration time and is related to the dosage of salt.
The selected value is established by the manufacturer and can only be changed under the
supervision of the installer.
1) After setting the days for the regeneration, one of the following letters will be displayed on the
screen: S, L, H
2) press so that the screen starts to blink
3) with the buttons select L (fig. 17)
4) press to confirm.
Programming finished.
SAVING THE SELECTED DATA
To prevent the program from being modified, you can block the data settings with the following
procedure:
press simultaneously
all the parameters will be displayed:
- P1 current time
- P2 current date
- P3 regeneration time
- P5 regeneration days
- P6 dosage of salt
- P7 salt amount
- P9 USA unit system / metric
- P10 0-12 h / 1-24 h clock selection
- P11 salt alarms ON/OFF
To block the value setting, press the
A padlock will be displayed
The values can be unblocked following the same procedure.
16
EN
buttons you can move it back and forth to the days you want the
until "P1" is displayed at the bottom of the screen. By pressing
button.
.
fig. 17
again,