Compressor Lubrication - Speedaire 2NYC1 Instrucciones De Funcionamiento Y Manual De Piezas

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Speedaire Operating Instructions and Parts Manual
Speedaire
Pump Parts Kits
Procedures (Continued)
7. Install new cylinder/crankcase o-ring.
8. Reinstall cylinder block. Piston rings
must be compressed when pistons
E
are inserted into the cylinder.
N
9. Reinstall cylinder/crankcase bolts
G
and washers to torque value speci-
L
fied in torque chart.
I
S
10. Proceed with steps 6-10 from valve and
H
o-ring repair kit instructions.
LIMITED WARRANTY
DAYTON ONE-YEAR LIMITED WARRANTY. SPEEDAIRE ® TWO-STAGE AIR COMPRESSOR PUMP PARTS KITS, MODELS COVERED IN THIS MANU-
AL, ARE WARRANTED BY DAYTON ELECTRIC MFG. CO. (DAYTON) TO THE ORIGINAL USER AGAINST DEFECTS IN WORKMANSHIP OR MATERIALS
UNDER NORMAL USE FOR ONE YEAR AFTER DATE OF PURCHASE. ANY PART WHICH IS DETERMINED TO BE DEFECTIVE IN MATERIAL OR WORK-
MANSHIP AND RETURNED TO AN AUTHORIZED SERVICE LOCATION, AS DAYTON DESIGNATES, SHIPPING COSTS PREPAID, WILL BE, AS THE
EXCLUSIVE REMEDY, REPAIRED OR REPLACED AT DAYTON'S OPTION. FOR LIMITED WARRANTY CLAIM PROCEDURES, SEE "PROMPT DISPOSI-
TION" BELOW. THIS LIMITED WARRANTY GIVES PURCHASERS SPECIFIC LEGAL RIGHTS WHICH VARY FROM JURISDICTION TO JURISDICTION.
LIMITATION OF LIABILITY. TO THE EXTENT ALLOWABLE UNDER APPLICABLE LAW, DAYTON'S LIABILITY FOR CONSEQUENTIAL AND INCIDEN-
TAL DAMAGES IS EXPRESSLY DISCLAIMED. DAYTON'S LIABILITY IN ALL EVENTS IS LIMITED TO AND SHALL NOT EXCEED THE PURCHASE PRICE
PAID.
WARRANTY DISCLAIMER. A DILIGENT EFFORT HAS BEEN MADE TO PROVIDE PRODUCT INFORMATION AND ILLUSTRATE THE PRODUCTS IN THIS
LITERATURE ACCURATELY; HOWEVER, SUCH INFORMATION AND ILLUSTRATIONS ARE FOR THE SOLE PURPOSE OF IDENTIFICATION, AND DO NOT
EXPRESS OR IMPLY A WARRANTY THAT THE PRODUCTS ARE MERCHANTABLE, OR FIT FOR A PARTICULAR PURPOSE, OR THAT THE PRODUCTS
WILL NECESSARILY CONFORM TO THE ILLUSTRATIONS OR DESCRIPTIONS. EXCEPT AS PROVIDED BELOW, NO WARRANTY OR AFFIRMATION OF
FACT, EXPRESSED OR IMPLIED, OTHER THAN AS STATED IN THE "LIMITED WARRANTY" ABOVE IS MADE OR AUTHORIZED BY DAYTON.
Technical Advice and Recommendations, Disclaimer. Notwithstanding any past practice or dealings or trade custom, sales shall not include
the furnishing of technical advice or assistance or system design. Dayton assumes no obligations or liability on account of any unauthorized rec-
ommendations, opinions or advice as to the choice, installation or use of products.
Product Suitability. Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of products for certain
purposes, which may vary from those in neighboring areas. While attempts are made to assure that Dayton products comply with such codes,
Dayton cannot guarantee compliance, and cannot be responsible for how the product is installed or used. Before purchase and use of a product,
review the product applications, and all applicable national and local codes and regulations, and be sure that the product, installation, and use
will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or limitation of inci-
dental or consequential damages, so the above limitation or exclusion may not apply to you; (b) also, some jurisdictions do not allow a limitation
on how long an implied warranty lasts, consequently the above limitation may not apply to you; and (c) by law, during the period of this Limited
Warranty, any implied warranties of implied merchantability or fitness for a particular purpose applicable to consumer products purchased by
consumers, may not be excluded or otherwise disclaimed.
Prompt Disposition. A good faith effort will be made for prompt correction or other adjustment with respect to any product which proves to
be defective within limited warranty. For any product believed to be defective within limited warranty, first write or call dealer from whom the
product was purchased. Dealer will give additional directions. If unable to resolve satisfactorily, write to Dayton at address below, giving dealer's
name, address, date, and number of dealer's invoice, and describing the nature of the defect. Title and risk of loss pass to buyer on delivery to
common carrier. If product was damaged in transit to you, file claim with carrier.
Manufactured for Dayton Electric Mfg. Co., 5959 W. Howard St., Niles, Illinois 60714-4014 U.S.A.
Two-Stage Air Compressor
®
Maintenance

COMPRESSOR LUBRICATION

fill the crankcase with compressor oil
as indicated in the chart.
Temperature
32
o
F - 120
o
F
Below 32
o
F
2NYC1, 2NYC2, 2NYC3 and 2NYC4
Use Model 4ZF21 (ISO 100) industrial
grade air compressor oil. This compres-
sor requires a non-detergent
Before operating
napthenic type oil with foam, rust and
the compressor,
oxidation inhibitors.
NOTE: Use of automotive engine oil
will cause carbon deposits to build up
Viscosity
on the valves. This will shorten the life
expectancy and will require more fre-
(SAE 30) ISO100
quent service to the valves. Do not use
(SAE 20) ISO 68
ATF, hydraulic fluid, two-cycle or any
oil treatment products. Do not use
diester synthetic oil.
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2nyc22nyc32nyc4

Tabla de contenido