Scope Of Supply - SOLAMAGIC D1 Manual De Montaje Y De Uso

 Installation tasks must be properly carried out by a qualified person in
accordance with VDE 0100 installation instructions (if applicable, also
including Parts 559 and 701).
 When carrying out any work on the electrical system, always switch to a
zero-volts state (pull out the plug, circuit-breaker off). Switch on the
heater only after all cables have been completely connected.
 The heater must be protected with at least a 16A (slow) fuse.
 Do not install directly under sockets, junction boxes, switches or
electrical cabling.
 Electrical sockets may only be located in the positions specified in
Appendix 2.
 Do not mount the heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
 The heater is rated IP 20 and is only authorised for indoor use.
 If being used in wet rooms, observe the installation instructions, VDE
0100, Part 701. Heaters must be installed in bathrooms such that the
switch cannot be touched by a person in the bath or under the shower.
 No not leave the heater unattended.
 Do not cover the heater when it is switched on or still hot; there is a risk
of fire.
 This heater is not equipped with a room temperature control unit and
must not be used in small rooms that are inhabited by people who
cannot leave the room independently, unless constant supervision is
ensured.
 To adjust the radiation direction, switch the heater off and allow to cool.

Repair work (e.g. replacement of a defective power lead) must only be carried
out by the customer service of the manufacturer or an authorised dealer.
 Cleaning and maintenance work must only be carried out by adults with
sufficient expertise.

Scope of supply

Infrared radiant heater
2 pcs. T-wall/ceiling brackets including fasteners
Hand-held transmitter (only with remote control version)
Installation and Instruction Manual
02/2015