HoMedics mybaby MYB-S300 Manual De Instrucciones E Información De Garantía página 4

Using the Picture Projection
NOTE: The projector door must be completely closed, pushed all the way up, in order
for the picture projector to function (Fig 6).
1. Turn on the picture projection on by pressing the PROJECTION ON/OFF button (Fig 3).
2. To adjust the brightness of the projection, turn the HI/LO knob (Fig 5) to your desired level.
3. The angle of the projector can be adjusted by angling forward up to 90°
4. When finished using the picture projection you may turn it off by pressing the PROJECTION
ON/OFF button.
NOTE: SOUNDS and PROJECTION are independent functions. You can use one at a time or
both combined.
FIGURE 5
HiGH/lo
KnoB
Front
oF unit
BaCK oF unit
6
FIGURE 6
proJECtor door
up For proJECtion
doWn For diSC
JaCK
diSC StoraGE SlotS
FIGURE 7
proJECtion lEnS
imaGE
diSC
diSC HoldEr
proJECtor
door
diSC StoraGE SlotS
Changing the Image Disc
1. Make sure projection is off, then slide down the projector door and pull out the disc holder (Fig 7).
2. Gently remove the current disc and set aside (Fig 7).
3. Select a new disc from the disc storage slots (Fig 6) and place into the disc holder so that you can see the word "UP"
printed on the disc (Fig 8).
4. Slide the disc holder back into the unit and push projector door up to close (Fig 6).
NOTE: The projector door must be completely closed, pushed all the way up, in order for the
picture projector to function (Fig 6).
5. Put original image disc into empty disc storage slot (Fig 6).
FIGURE 8
imaGE
diSC
"up"
diSC HoldEr
proJECtor
door
7