How To Install Batteries; How To Use - HoMedics mybaby MYB-W10 Manual De Instrucciones E Información De Garantía

Congratulations!
Thank you for purchasing the MyBaby by Homedics Automatic Soap
Dispenser. The Automatic Soap Dispenser will engage your child's
imagination while helping them to learn proper hand washing technique.
Features:
• Works with any type of liquid hand soap
• Motion sensor technology provides sanitary, hands-free operation
• Magnetically attached drip tray removes easily for cleaning
• Self-cleaning function prevents clogs and mess
• 20 second training song

How To Install Batteries:

Use a coin to turn the Battery/Control Compartment door screw to the "open" position
(Figure 1). Open the Battery Compartment door. Insert three (3) AA alkaline batteries
carefully, following the polarity (+/–) markings shown inside the battery compartment
(Figure 2).
Note: when the batteries are low and need replacing, the red LED Low Battery Indicator
(Figure 3) will flash for 10 seconds after each dispensing cycle.
CLOSED
SONG ON/OFF
Figure 1
OPEN
2
POWER ON/OFF
function
CLEAN function
function
SONG CLEAN
+ +
– –
Figure 2

How To Use

1. Lift the cover to the Soap Reservoir, remove the plug and fill the reservoir up to
the "MAX" line. Do not overfill as this may cause dripping. Replace the plug in
the soap reservoir securely.
Caution: All
2. Open the Battery & Control Compartment on the bottom of the unit and press
servicing of
the POWER button. The Red LED will turn on for 12 seconds while the unit is in
this product
Setup Mode. During this period, the Motion Sensor and motor will not function.
must be
This will allow enough time to close the Battery & Control Compartment door
performed by
and position the unit without triggering the Motion Sensor.
authorized
3. Attach the Drip Tray by placing as shown below. Magnets help to secure in
HoMedics
position.
Service
4. Place your hand under the spout to activate the Motion Sensor. The Soap
Personnel
Dispenser will then dispense soap and play the training Song.
only.
Note: The Soap Dispenser will automatically turn the Song Mode to ON when
the device is powered ON. To turn Song Mode OFF, press the SONG button
(Figure 2) once.
Soap Reservoir
Figure 3
Spout
Red LED:
Indicates Motion Sensor
is not active during Setup
Mode; Flashes to indicate
low battery condition
Motion Sensor
Drip Tray
3