Kenmore 795.7310 Serie Manual De Uso Y Cuidado página 15

Replacing the Left Door
Install the left refrigerator door after the right door is
installed.
1 Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator door
onto the middle hinge.
2 Fit the hinge (1) over the hinge lever latch and
slot it into place. Rotate the lever clockwise (2)
and fasten the hinge.
Hinge Lever Latch
3 Connect all the wire harnesses.
4 Push the water supply tube into the hole on the
top case and pull it through the backplate.
REFRIGERATOR INSTALLATION
5 Hold the water supply connection and gently push
in the collet (1) to connect the water supply line
(2) as shown. Insert the tube at least 5/8 inch (15
mm) into the connector. Insert the clip on the joint
to fasten the tube in place.
6 Place the cover (1) in place. Insert and tighten the
cover screw (2).
NOTE
Disassembling/Assembling the Water Lines
Collet
Tube
Insert line
Clip
Gently press the collet and insert the tube until only
one line shows on the tube.
(Correct)
15
Collet
(Correct)
(Incorrect)