Technical Data; Power Requirements - Truper COMP-25LT Manual De Instrucciones

Compresor de aire lubricado
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Technical Data

Code
Description
Voltage
Frequency
Power
Maximum Pressure
Air Continuous Flow
Tank Capacity
Conductors
Insulation
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING

Power Requirements

WARNING
If faults or breakdowns happen. Ground connection offers a
trajectory with minimum resistance for electric power. It reduces the risk of electric
shock. This tool is built with a power cable with an earth conductor and ground
connection. The plug shall be connected into a power outlet installed and grounded
according to all local codes.
CAUTION
A power extension cord is not recommended to use with a compressor. Using an extension causes voltage
drop, power loss in the motor and overheating. Instead of using an extension cord, increase the compressor's action scope
connecting a longer length of hose into the outlet. Connect additional hose lengths as required. Likewise, if needing to use
a pneumatic tool outdoors in humid environment or even when raining, operate the compressor from the inside keeping it
guarded from humidity. Operate the pneumatic tool connected to the compressor through additional lengths of hose
without the risk of electric shock.
• In the event of connecting the compressor into a circuit protected with fuses, use delay action fuses type "D".
WARNING
This tool SHALL BE USED with
115 V ˜ to 125 V ˜ feed. Using a
DIFFERENT VOLTAGE WILL
SEVERELY DAMAGE the product.
COMP-25LT
15006
Rated: 2 Hp Maximum: 3 Hp
6.6 Gallons
16 AWG x 3C with 221 °F Insulation Temperature
Power cord grips used in this product: Type "Y".
Build quality: Basic insulation
Thermal insulation on motor winding: Class F
COMP-50LT
15007
Lubricated air compressor
120 V
60 Hz
Rated: 2-1/2 Hp Maximum: 3-1/2 Hp
116 PSI
4,4 CFM - 40 PSI
3,4 CFM - 90 PSI
13.2 Gallons
Class I
Authorized Service Center.
3
ENGLISH

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Comp-50lt1500615007

Tabla de contenido