Nilfisk SDV 8000 Manual De Usuario página 8

Technical
Boiler
Wattage:
3000W – (2000+1000)
Type:
Stainless Steel
Capacity:
3.3 Litres
Continuous Fill
Steam Pressure:
8 Bar
Steam at source:
165°C >
Vacuum
Type:
Integral
Motor:
850 Watt
Electrical
Voltage:
230V ~ single phase
Low Voltage Controls:
5V
Cord length:
10m
Capacities
Boiler:
3.3 Litres
Cold Water Tank:
5 Litres (easy fill)
Collection Tank:
12 Litres
Detergent Tank:
2.5 Litres (easy fill)
Weight:
35kg
English
Trouble
Shooting
No Power
Not connected Check
or faulty connection to
power cable wall socket and
socket switch.
Try in another
wall socket
On / Off Press On / Off
switch not on switch which
will illuminate
when on
Fuse blown
Replace fuse
with approved
13A fuse
Unknown Call for service
No steam
Steam Control Turn the
turned down control to half
fully way
clockwise
Steamer not Wait for the
ready
"Ready to
steam" light to
illuminate
Clean water Pour water into
tank is low the clean water
(beeping tank until the
sound& beeper stops.
"refill" light is The steam
lit)
handle will
work again.
Unknown Call for service
No steam, Just water
Steamer not
Wait for the
ready "Ready to steam "
light to illuminate
Boiler at Hold the steam
pressure switch on for
and not approximately
heating(tem one minute, ever
perature if just water is
less than coming out. This
110ºC) will result in the
heater coming
back on
Unknown Call for service
Page 8
Steam Leaking from
front socket
"O" Rings
Change and re
split grease "O" Rings.
To avoid this
happening ensure
"o" rings are grease
before every use.
"O" rings Change and re
worn grease "O" Rings.
To avoid this
happening ensure
"o" rings are grease
before every use.
Vacuum power low
Vacuum
Operate any of the
operation handle controls,
has been which will reset the
selected motor power to full.
on the
Continue
machine vacuuming
High pitch Switch the machine
motor off and empty the
noise collection tank.
Refill the collection
tank with clean
water to the mark
and recommence
work.
Unknown Call for service
No detergent
Solution tank
Pour cleaning
empty solution diluted
in accordance
with the
manufacturer's
instructions into
the solution
tank.
Unknown Call for service