Initial Setup; Input Source; Navigating The On-Screen Menu; Picture - Haier 55UG6550G Manual De Instrucciones

INITIAL SETUP

will guide you through setting up basic settings.
1. Press to turn on the TV. The setup wizard screen
opens. Press OK to start the wizard.
Home Mode or Store Mode
2. Press to select
then press to continue.
n I t i l a i S e u t p
Home mode
Store Mode
3. Press to select your tuner type, then press
to start channel scan.
n I t i l a i S e u t p
n I t i l a i S e u t p
Air – Set the signal type to antenna. When set to
Air, the TV can receive analog and digital (ATSC)
broadcasting signals.
Cable – Set the signal type to cable. When set to
Cable, the TV can receive analog and QAM
broadcasting signals.
6. The auto channel scan usually takes a few minutes
to complete but can take up to 20 minutes. You can
cancel the channel scan by pressing
NOTE
During initial setup, press EXIT to exit the initial setup.
,
Welcome
L a n g u a g e
Welcome
Air
Cable
.
EXIT

INPUT SOURCE

Press INPUT to open the input source list, then press
to highlight an input and press OK to switch.

NAVIGATING THE ON-SCREEN MENU

1. Press MENU button to display the main menu.
2. Press button to select what you want set.
3. Press OK to enter setting.
NOTE
Press MENU to return to the previous menu. If the main
menu is displayed, pressing MENU will close the on-
screen menu.

PICTURE

11