Double Insulated Tools; For Your Safety; Extension Cords; Getting Started - UltraHEAT SV 750 Manual De Instrucciones

Double Insulated Tools

Tools marked with the words "Double Insulated" are equipped with a two prong plug.
These tools have a special insulation system that complies with applicable UL and CSA
standards. They do not require grounding. "Double Insulated" tools, like this one, have
two prong cords and can use either a two or three prong extension cord.
"This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a quali-
fied electrician. Do not modify the plug in any way."

Extension Cords

As the distance from the supply outlet increases,
heavier gauge extension cords are required. The use
of extension cords of inadequate size wire causes a
serious drop in voltage and loss of power. Protect the
cord from damage. Keep cords away from excessive
heat, sharp edges and damp or wet areas. Repair or
replace damaged extension cords before using.

Technical specifications

Voltage
120 V / 60 Hz
Output 1750 W
Airflow
up to 23 CFM, adjustable with baffle
Temperatures
Level 1: 80°F
Level 2: 750°F – 1000°F
Protection class
II (without neutral lead connection)
English
Ext. Cord Length
85 Ft.
100 Ft.
170 Ft.
270 Ft.
400 Ft.
650 Ft.
- 6 -

For your safety

This heat tool incorporates a thermal fuse which automatically switches the device off in cases of
severe overheating.

Getting started

Operation
The device is switched on and
off with the selector switch on
the front of the handle. The dis-
Wire Size
tance from the object being
14
processed depends on the
12 material and the intended type
of processing. Always do an
10
08
06
Temperature Selection
04
Level 1 is the cool air setting.
The temperature is approximate-
ly 80°F (room temperature). Use
Adjustable Baffle
5
Turn the baffle
the air and temperature.
Turning the baffle toward LO
Working with the stand
6
Support Stand
adjusted or removed by loos
English
initial test with regard to air vol-
ume and temperature. With the
optional accessory nozzles (see
accessories on page 3), the
hot air can be precisely target-
ed to specific points or sur-
faces. Exercise caution when
the cool air function to dry paint,
to cool workpieces or to cool
the nozzle before changing an
lowers the temperature while
to adjust
increasing the airflow. Turning
the baffle toward HI increases
may be ening clamp screw. Stand
may be securely fastened to
- 7 -
changing hot nozzles! When
you use the heat gun as a sta-
tionary device, ensure that it is
positioned securely on a clean
surface so that it cannot slip.
accessory part. At Level 2 the
blower temperature is 750 –
1000°F
the temperature while decreas-
ing the airflow.
work bench via holes in base.