Connecting A Computer; Using The Basic Controls; Turning The Tv On And Off; Adjusting The Volume - Insignia NS-LTDVD26-09 Guia Del Usuario

Connecting a computer

To connect a computer using VGA:
1 Remove the port cover (1) from the back of
your TV.
2 Plug a VGA cable (4) into the VGA port on
the computer (6) and into the VGA INPUT
port on the back of your TV.
3 Plug an audio cable (5) into the audio jack on
the computer (6) and into the AUDIO VGA
INPUT port on the back of your TV.
4 Turn on your TV.
5 Press INPUT, then press
Caution
The TV will automatically turn off after one minute
if there is no signal in PC mode.
To connect to a computer or other HDMI
device using the HDMI jack:
1 Remove the port cover from the back of your
TV (1).
2 Plug an HDMI cable (2) into the HDMI port on
the HDMI device (3) and into the HDMI
INPUT port on the back of your TV.
3 Turn on your TV.
4 Press INPUT, then press
HDMI.
Note
When the computer goes into standby mode, your
TV turns off. If your TV does not turn on when you
"wake" your computer, press the POWER button
on your TV or remote control.
12

Using the basic controls

Turning the TV on and off

Adjusting the volume

Changing the video mode

Using your TV

Selecting the TV signal source

/
to select PC.
/
to select
www.insignia-products.com
Insignia NS-LTDVD26-09 26" LCD TV/DVD Combo
To turn your TV on and off:
1 Press POWER on the side of your TV or on
the remote control. The POWER/STANDBY
indicator turns blue.
2 To turn off your TV, press POWER again. The
POWER/STANDBY indicator turns red.
You can adjust the volume using the controls on
your TV's side panel or the remote control.
To adjust the volume:
1 Press VOL+ or VOL- to increase or decrease
the volume.
2 Press MUTE to mute the sound, then press
this button again to restore the sound.
Your TV supports multiple video modes.
To select the video mode:
• Press INPUT one or more times to select the
video mode, then press ENTER. You can
select:
• TV
• AV1
• AV2
• S-Video
• Component
• DVD
• HDMI
• PC (VGA)
To select the TV signal source:
1 Press TV MENU, then press
highlight CHANNEL. The CHANNEL menu
opens.
to enter the CHANNEL menu.
2 Press
/
3 Press to select TV Source, then press
/ to select Air or CATV.
• Air-VHF/UHF channels.
/ to