Instructions To The User - Time Warner Cable URC-1047 Guia Del Usuario

TROUBLESHOOTING (continued)
PROBLEM:
SOLUTION: Follow instructions in Changing Volume Lock
PROBLEM:
SOLUTION: Due to RCA design (1983-1987), only the original
PROBLEM:
SOLUTION: Try the "Search Method" again after clearing out
PROBLEM:
SOLUTION: For power on, these products require program-

INSTRUCTIONS TO THE USER

This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
No volume on a second TV.
(see page 17).
CH+ , CH – , and LAST do not work for your
RCA TV.
remote control will operate these functions.
Tried "Search Method" and still could not find a
working code.
the device key as follows: Press and hold SETUP
until mode key blinks twice, then release. Next
enter 9 - 9 - 2. Then press and release the mode
key to be cleared twice.
Remote control does not turn on Sony or Sharp
TV/VCR Combo.
ming TV codes on the remote control. For Sony,
use TV code 0000 and VCR code 0032. For Sharp,
use TV code 0093 and VCR code 0048.
18