Connection To The Pipe Network - Sistem-Air TECNO PRIME Manual Tecnico

6.4 Connection to the piping network
1. Using the sleeve, connect the dust inlet coupling of the cyclonic vacuum cleaner, identifi ed with (A)
in the picture, to the suction pipe from the piping network.
2. By using the sleeve, connect the air outlet of the central vacuum unit, marked with (B), to the air outlet
of the house.
3. Glue the silencer (C) on the exhaust pipe near the exhaust air grid.
N.B.: do not glue the pipe end of the network pipe to the dust inlet coupling or to the air exhaust coupling:
always use the sleeves provided.
Should it be necessary to convey the air discharge to the outside, please follow the following
instructions:
Maximum length of the discharge pipe:
Diameter of the outlet pipe for a length up to 4 m:
Diameter of the outlet pipe for lengths from 4 to 6 m:
Diameter of the outlet pipe for lengths from 6 to 8 m:
Diameter of the outlet pipe for lengths from 8 to 10 m:
It is not advisable to use an outlet pipe which is longer than 10 m, because this could damage
the central vacuum unit.
04/06/2019 Rev:1.0.0
C
B
A
For the installation of the TECNO
PRIME unit with the bag fi ltration
confi guration see the integrative
manual.
50 mm
63 mm
80 mm
100 mm
2
11