Warranty Conditions - HEISSNER F640S-00 Manual De Funcionamiento

DESCRIPTION AND ASSEMBLY INSTRUCTIONS
A Motor head
B Switch
C Drainpipe (WASTE WATER)
D Filter (WASTE WATER)
F Stopper for tank
G Latches for closing head/tank
H Vacuum connection
HOW TO OPERATE
(−) MANUAL: manual operation (wet & dry vacuum cleaner function)
(0) OFF: machine switched off
0
(=) AUTOMATIC: operation (pond cleaner function)
USAGE AS POND CLEANER
Be sure that switch is in off position (0) OFF and connect the machine to a suitable socket.
�
Place the machine near the pond/lake keeping safety distance of 2 mt from the border.
�
The machine must be always kept on horizontal bases, in a safe and stable way.
�
Place the drainpipe C in the correct direction where the full tank will be discharged from waste water
�
previously vacuumed.
Check that the drainpipe is lowered so that the water drains off and avoid that the machine and electric
�
cable get wet.
Insert the suitable filters for the proper use.
�
Immerge extension hoses M with the pond cleaner nozzle O in the water, reacing the bottom of the
�
pond/lake.
Put switch B on (=) AUTOMATIC position in order to start the machine.
�
The machine starts working approximately 10 sec. later to allow the operator to join the working position.
�
After a working cycle of about 40 sec. the machine switches off automatically for 40 sec. to allow drain-
�
ing of the tank.
When draining cycle is finished the machine starts automatically.
�
In case of tank filling before 40 sec. during vacuum phase, the internal gauge of the motor head stops
�
the vacuum function. Leave the machine working.
The waste water vacuumed is collected from filter D situated in the final part of the drainpipe C.
�
Be sure that draining filter D do not prevent the flow of the water. Otherwise clean it.
�
When job is over, switch off (0) OFF and keep away the plug from the socket.
�
Drain waste water from the tank and clean the accessories before storing the machine.
�
USAGE AS "WET & DRY VACUUM CLEANER"
Be sure that the switch is placed in position (0) OFF and connect the machine to a suitable socket.
�
Insert the proper filter suitable for the requested usage.
�
Put the stopper F on the tank I.
�
Use the most suitable accessories for the requested usage.
�
Place the switch B on (–) MANUAL position to start the machine.
�
When the switch is placed on (–) MANUAL position, the machine works continously, without on/off cycles.
�

WARRANTY CONDITIONS

This is a top quality appliance and has been made in accordance with current technological know-how
and with carefully selected materials. It is covered by a 24- month guarantee that starts from when the
appliance is delivered. If the guarantee has to be used you must show the receipt or invoice.
During the guarantee period our assistance centre will repair all those malfunctions that, despite the user
has followed the instructions in our manual, can be put down to defective materials.
The parts deemed faulty will either be replaced or repaired under the guarantee. The replaced parts remain
our property. Replacements or repairs do not extend the guarantee period; for the parts replaced, the
appliance's period of guarantee is valid. We are not held responsible for damages or faults to the appli-
ance or to any of its components if they are caused by an improper use or maintenance of the appliance.
F640S Betriebsanleitung-Garantie.indd 13
I Tank
L Flexible hose (for powders/liquids)
M Extension tube
(for powders/liquids)
O Pond cleaner nozzle
Q Handle with air control valve
R Filter (wet cleaner)
1 EN
13
16.08.2017 17:03