Troubleshooting - Bissell REVOLUTION PET PRO 1986 Serie Guía De Inicio Rápido/Del Usuario

Troubleshooting

WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
Problem
Reduced or No
Spray Through
Foot of Machine
No spray
through
hose & tool
No Spray
Through
CleanShot®
CleanShot®
Continues Spray
When Machine
is Off
Loss of
suction
power
No power
Leaking tank
20
www.BISSELL.com
Possible causes
Clean water tank may be empty
Clean water tank may not be
seated completely
The hose to your machine is not primed or
may have lost prime
Clean Water tank may be empty
Clean Tank may not be seated properly
Clean Water tank may be empty
Clean Tank may not be seated properly
The machine is not reclined
Pump may have lost prime
CleanShot® button is not in the "OFF"
position
Dirty tank may not be seated properly
Dirty tank has picked up maximum amount
of dirty water and has reached full line
Rubber tab on dirty water tank is not sealed
tight
Accessory hose door may not be closed
tightly in place
Nozzle may be clogged from pet hair or
debris
Brush roll cover not fully snapped into place
Cleaning mode switch mistaken for power
button
Outlet may not be active
Tank may have been over-filled
Water may be caught in space between the
tank and the tank's handle
Remedies
Refill tank
Turn power OFF; remove and reseat tank
1. With the machine off and unplugged, remove the nozzle from
the foot. Place a ball point pen in the black cylinder next to the
screw. When water bubbles up, remove the pen. Reassemble the
nozzle and hose
2. Hold end of hose below water level in tank to prime
3. With the clean tank full of water, the machine OFF and
RECLINED, press the CleanShot® button ON and wait for the
CleanShot® to drain for a few seconds; This will re-prime the
machine
Refill the Clean Water Tank
Turn power OFF; Remove and reseat the clean water tank
Refill the Clean Water Tank
Turn power OFF; Remove and reseat the clean water tank
Press the Recline pedal and bring the handle down to recline the
machine
With the machine off and unplugged, remove the nozzle from the
foot. Place a ball point pen in the black cylinder next to the screw;
When water bubbles up, remove the pen; Reassemble the nozzle
before cleaning again
Press the CleanShot® button to turn it off. The button window will
show the color red and a "O" symbol when it is in the off position
Pick up the dirty tank and reseat so it fits in the unit
Empty dirty tank
Check the rubber tab on the dirty water tank and press firmly on all
edges to secure it tightly (see step 4 on page 16 for detail)
Check the accessory hose door and make sure it is closed tightly – it
should be locked into place
Use the nozzle clean out tool and follow steps on page 17 for
"Cleaning Nozzle"
Remove the nozzle and brush roll cover; Follow step 6 from page 18
and make sure you hear both buttons click into place
Press the red power button on the left side of the machine to turn
the machine on
Try plugging in a different device that uses a grounded outlet to test
for power from the outlet
1. Make sure your tank has the water and formula in it that you've
prepared
2. With the cap twisted ON tightly, hold your tank at an angle, over a
sink or drain, so any extra water can pour out of the space
3. Wipe the tank dry with a cloth