Descargar Imprimir esta página

Kübler CODIX 550 Manual Del Usuario página 38

Controlador de proceso para señales de corriente y tensión
Ocultar thumbs Ver también para CODIX 550:

Publicidad

Idiomas disponibles

Idiomas disponibles

5 5 . . 6 6 . . 2 2 S S e e l l e e c c t t a a d d d d r r e e s s s s
Menu <–> Selection
press the
5 5 . . 7 7 S S e e t t t t i i n n g g D D e e f f a a u u l l t t V V a a l l u u e e s s
The user has the possibility to set all pa-
rameters back to their default values by
using the parameter
rameter
must be programmed
with the value
ceed to the next parameter using the keys,
Menu <–> Selection
press the
5 5 . . 8 8 E E n n d d o o f f S S e e t t u u p p Y Y e e s s / / N N o o ? ?
Menu <–> Selection
press the
5 5 . . 9 9 C C h h e e c c k k / / A A l l t t e e r r P P a a r r a a m m e e t t e e r r s s
Menu <–> Selection
www.kuebler.com
Example: device address 12
Select digit
Set digit
key to accept
. This pa-
If you then pro-
Select digit
Set digit
key to accept the selection
Parameters will be stored -> Operation
Check/alter Parameters
key to accept the selection
Checking the individual menu items
• after every 2 seconds the menu changes
to Selection
• If the setting is as desired, then switch to the next menu
with
key, otherwise, start the set-up again.
then all parameters are reset to their de-
fault values. It is not necessary to finish
the programming; a new programming
cycle can take place immediately.
Chapter 5.9,
17
Page 17

Publicidad

loading