Bartscher 109.470 Mantenga Las Instrucciones página 26

Polishing glasses
•
Connect the unit to a grounded single socket.
•
To turn the unit on, put the ON / OFF switch in the position marked „I". To turn the
unit off when in use, put the switch in the position marked „O".
•
Before using, let the unit heat up for approx. 15 minutes.
CAUTION!
Only polish clean glasses.
Only wash glasses at temperatures below 70° C!
•
Glasses must be wet for them to be polished.
•
The microfibre cloths absorb moisture in a few seconds, which is why the cloths are
dried by having hot air blown on them. This keeps the polishing head cloths
constantly dry.
•
Take a wet and washed glass and proceed as follows:
Glasses with bases should have the bases dried first. Hold the bottom of the
glass against a polishing cloth.
Turn the glass and move the glass base between the polishing heads, turning it
vertically back and forth to ensure the entire base is dried and polished.
At the end, place the glass on one of the polishing cloth heads; the interior of the
glass and its base are dried immediately. The exterior is dried by contact with the
other four polishing heads.
WARNING! Risk of injury!
To avoid injury, do not bring your hands near the hot air exhaust.
•
Turn the unit off using the ON / OFF switch and remove the plug if the unit is not to
be used any longer.
CAUTION!
To avoid overheating, turn the unit off after 2 hours of work and leave to cool
for 5 minutes.
- 26 -