Fault Indications And Rectification Of Faults - CASO DESIGN WineSafe 18 EB Manual Del Usuario

15.2 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Wine refrigerator
operate.
Wine refrigerator is not cold
enough.
The light does not work.
Vibrations.
The wine refrigerator seems
to make to much noise
The door will not
properly.
LED could not display.
LED display error - Lo
Buttons are not functional.
Compressor will not start
Compressor re-start
Dew on the surface
cabinet：
Liquid sound
do not Not plugged in using different voltage. The circuit breaker
tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct clearance.
Please contact customer service.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.
close The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak. The shaves out of position.
Main control board does not work. PCB Problem.
There is some problem with the plug.
Display problem.
PCB problem. Check the service center.
Temperature controller panel is damaged.
Room temperature is lower than desired temperature.
Compressor will stop working when cooling system in the
cabinet reaches
working until the desired temperature is achieved.
Allow a minimum 5 minute interval before re-starting.
of The surface of wine cabinet especially the glass door
appear some frost if item in a damp room. This is due to
the moisture in the air coming into contact with the cabinet.
Please wipe it away with dry cloth.
1) The sound of compressor when starts or stops working
2) The flowing sound of refrigerant in the refrigeration
system
Possible Cause
presetting temperature, and re-start
40