Midea Keystone KSTAT12-1A Manual Del Usuario página 16

Wall Sleeve Brands:
7
60
Top View
Rear Louvers
60
#1 Emerson
1. Redirect the louvers at the back of the wall
sleeve as shown in the illustration. The use
of pliers is recommended.
1
/
2. Attach(1)1 x3/8 x25 long seal in the center at
2
the top of the sleeve. Remove the backing paper
and press into position.
1
/
3. Attach the (2) 1 x3/8 x14 long seals to the
left and right sides of the sleeve.
4. Cut the 1 1 x3/8 x25 long seal to 14 long, and
/
2
attach it to the vertical section of the rear grille
as shown.
1 1
/
5. Attach (2)4 x3
2
one on each side wall. Place in center of side
wall with the tapered end facing the opening.
6. Gently slide unit into sleeve.
7. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
8. Remove the plastic washer from the screw.
9. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
10.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
11.Seal & Frame the unit as described on the last
page of these instructions.
12
15 Deep
2
/
x1 1 centering/support blocks
/
2
2