Maintenance; Emptying The Collection Tank; General Maintenance; Filter Cleaning - Snapper XD Manual Del Propietário

MAINTENANCE

EMPTYING THE COLLECTION TANK

The collection tank must be emptied when it is full. Every now and then the dust
collection tank and the filter need to be cleaned to maintain a high suction power.
1. Turn off the machine.
2. Remove the battery packs.
3. Remove the top cover assembly.
4. Dump the collection tank contents into the proper waste disposal container.

GENERAL MAINTENANCE

• Before each use, inspect the entire product for damaged, missing, or
loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all
fasteners and caps and do not operate this product until all missing or
damaged parts are replaced.
• Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove dirt, dust,
lubricant, grease, etc.
• Always store the machine clean and in a dry enclosure with the battery
charged.

FILTER CLEANING

Your filter should be cleaned often to maintain peak vacuum performance.
Allow the filter to dry before storing or picking up debris.
IMPORTANT: After cleaning, check the filter for tears or small holes. Do not
use a filter with holes or tears in it. Even a small hole can allow dust to come
out of your vacuum. Replace it immediately.
Cleaning A Dry Filter
• Cleaning should be done outdoors and not in the living quarters.
• You can use a small brush to clean the dust and debris.
• For thorough cleaning of dry filter with fine dust (no debris), run water
through it as described under "Cleaning A Wet Filter"
Cleaning A Wet Filter
• Remove the filter from the machine.
• Run water through the filter from a hose or spigot.
NOTE: Check the filter for tears or small holes after cleaning. Do not use a
filter with holes or tears in it. Even a small hole can allow dust to come out of
your machine. Replace it immediately.
20